Nissan Versa Sedan. Instruction - part 191
DLK-82
< DTC/CIRCUIT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
DOOR LOCK ACTUATOR
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace harness.
3.
CHECK BCM OUTPUT SIGNAL
1. Connect BCM connector.
2. Check voltage between front door lock actuator RH harness connector and ground.
Is the inspection result normal?
YES
>> Check for internal short of each door lock actuator.
NO
>> Replace BCM. Refer to
BCS-69, "Removal and Installation"
REAR LH
REAR LH : Component Function Check
INFOID:0000000009268760
1.
CHECK FUNCTION
1. Select DOOR LOCK of BCM using CONSULT.
2. Select DOOR LOCK in ACTIVE TEST mode.
3. Touch ALL LOCK or ALL UNLK to check that it works normally.
Is the inspection result normal?
YES
>> Door lock actuator is OK.
NO
>> Refer to
DLK-83, "REAR RH : Diagnosis Procedure"
.
REAR LH : Diagnosis Procedure
INFOID:0000000009268761
Regarding Wiring Diagram information, refer to
DLK-50, "POWER DOOR LOCK SYSTEM : Wiring Diagram"
.
1.
CHECK DOOR LOCK ACTUATOR INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect rear door lock actuator LH connector.
3. Check voltage between rear door lock actuator LH harness connector and ground.
Is the inspection result normal?
YES
>> Replace rear door lock actuator LH.
NO
>> GO TO 2.
2.
CHECK DOOR LOCK ACTUATOR CIRCUIT
1. Disconnect BCM connector and all door lock actuator connectors.
BCM
Ground
Continuity
Connector
Terminal
M99
65
No
59
(+)
(–)
Condition
Voltage
(Approx.)
BCM
Connector
Terminal
M99
65
Ground
Door lock and unlock switch
Lock
12 V
59
Unlock
(+)
(–)
Condition
Voltage
(Approx.)
Rear door lock actuator LH
Connector
Terminal
D205
1
Ground
Door lock and unlock switch
Lock
12 V
2
Unlock