Volkswagen Corrado (1993 year). Manual - part 82

 

  Index      Volkswagen     Volkswagen Corrado - service repair manual 1993 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  80  81  82  83   ..

 

 

Volkswagen Corrado (1993 year). Manual - part 82

 

 

A/C COMPRESSOR OIL CHECKING 

COMPONENT REFRIGERANT OIL CAPACITIES (DIESEL KIKI 5 & 6-CYLINDER)

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Component                                                   Ounces

Condenser  ..................................................  1.0
Evaporator  .................................................  1.7
Receiver-Drier  .............................................  1.0
Refrigerant Lines  ..........................................  0.3

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

         FORD

         FX-15 10-CYLINDER

         1) Slowly discharge system. See SERVICING PRECAUTIONS. Remove
A/C compressor. Drain compressor oil from suction and discharge ports.
Measure amount drained and discard oil.
         2) If amount drained from removed (old) compressor is between
3 and 5 ounces, add drained amount of new refrigerant oil into the NEW
compressor through suction port.
         3) If amount drained is less than 3 ounces, add 3 ounces to
the NEW compressor. If amount drained is more than 5 ounces, add 5
ounces. Use new "O" rings on refrigerant lines. Install A/C
compressor. Evacuate and recharge system. Perform leak test.
         4) When replacing other A/C system components, add the
following amount(s) of refrigerant oil. See COMPONENT REFRIGERANT OIL
CAPACITIES (FX-15 10-CYLINDER) table.

COMPONENT REFRIGERANT OIL CAPACITIES (FX-15 10-CYLINDER)

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Component                                             Ounces

Condenser  ............................................  1.0
Evaporator  ...........................................  3.0
Receiver-Drier  ...................................  (1) 2.0
Refrigerant Lines  ................................  (2) 1.0

(1) - On Hyundai Sonata and Mazda Navajo, drain oil from old
      receiver-drier. Add amount drained to amount specified.
(2) - Add only if a large oil leak is indicated.

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

         HADSYS

         7-CYLINDER

         Honda (Accord)
         1) Discharge system. See SERVICING PRECAUTIONS. Remove
compressor from vehicle. Drain all oil from NEW compressor and fill
compressor with 4 ounces of clean refrigerant oil.

A/C COMPRESSOR OIL CHECKING 

         HARRISON

         R4 4-CYLINDER

         1) Before checking and adjusting oil level, operate engine at
800-1000 RPM. Set controls at maximum cooling and high blower motor
speed for 20 minutes to return oil to compressor.
         2) Stop engine. Discharge refrigerant and remove compressor
from vehicle. See SERVICING PRECAUTIONS. Remove oil drain plug and
measure amount of oil drained.
         3) If amount drained is less than one ounce, conduct leak
tests at system connections. Repair or replace faulty parts as
necessary. Fill compressor with 2 ounces, using new refrigerant oil.
         4) If amount drained is more one ounce, oil level is okay.
Fill compressor with same amount drained, using new oil.
         5) When replacing other A/C system components, add the
following amount(s) of refrigerant oil. See COMPONENT REFRIGERANT OIL
CAPACITIES (HARRISON R4 4-CYLINDER) table.

COMPONENT REFRIGERANT OIL CAPACITIES (HARRISON R4 4-CYLINDER)

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Component                                                Ounces

Condenser  ...............................................  1.0
Evaporator  ..............................................  1.7
Receiver-Drier  ..........................................  1.0
Refrigerant Lines  .......................................  0.3

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

         V5 5-CYLINDER

         1) If system is operable, run A/C system for several minutes
to stabilize system. Turn off engine. Discharge system and remove
compressor. See SERVICING PRECAUTIONS. Remove drain plug and measure
oil.
         2) If one ounce or more is drained, add same amount. If less
than one ounce is drained, add 2 ounces of new refrigerant oil to
compressor.
         3) If condenser is replaced, add one ounce. Add 3.5 ounces if
accumulator is replaced. If evaporator is replaced or if a large
refrigerant leak occurred, add 3 ounces of new refrigerant oil.

         HITACHI

         6-CYLINDER

         1) Before checking and adjusting oil level, operate
compressor at 1000-1500 engine RPM, and set controls at maximum

A/C COMPRESSOR OIL CHECKING 

         MATSUSHITA

         ROTARY VANE

         Geo (Prizm)
         1) If system is operable, run A/C system for several minutes
to stabilize system. Turn off engine. Discharge system and remove
compressor. See SERVICING PRECAUTIONS. Remove drain plug and measure
oil.
         2) If one ounce or more is drained, add same amount. If less
than one ounce is drained, add 2 ounces of new refrigerant oil to
compressor.
         3) If condenser is replaced, add one ounce. Add 3.5 ounces if
receiver-drier is replaced. If evaporator is replaced or if a large
refrigerant leak occurred, add 3 ounces of new refrigerant oil.

         Toyota
         Discharge system. See SERVICING PRECAUTIONS. Remove
compressor from vehicle. Drain oil from compressor through inlet and
outlet ports. Fill compressor with 3.4-4.1 ounces of oil through
suction port. Add 0.7 ounces if receiver-drier was replaced. When
replacing condenser or evaporator, add 1.4-1.7 ounces of refrigerant
oil.

         NIPPONDENSO

         ROTARY VANE

         1) Before checking and adjusting oil level, operate
compressor at engine idle speed, and set controls at maximum cooling
and high blower motor speed for 20-30 minutes to return oil to
compressor.
         2) Stop engine. Discharge refrigerant and remove compressor
from vehicle. See SERVICING PRECAUTIONS. Drain compressor oil through
compressor intake and discharge ports. Measure amount drained.
         3) Fill compressor with same amount as drained, plus one
ounce. When replacing condenser, add one ounce. When replacing
evaporator, add 1 1/2 ounces. When replacing receiver-drier, add 1/3

A/C COMPRESSOR OIL CHECKING 

         6 & 10-CYLINDER

NOTE:    Porsche and Suzuki compressor oil checking procedures are
         not available from manufacturer.

         Acura & Honda
         1) Discharge system. See SERVICING PRECAUTIONS. Remove
compressor from vehicle. Drain all oil from NEW compressor and fill
compressor with 3-4 ounces of clean refrigerant oil.
         2) On Accord, add 5/6 ounce of refrigerant oil when replacing
evaporator. Add 1/3 ounce when replacing condenser. When replacing
receiver-drier or hoses, add 1/3 ounce per component replaced.
         3) On Legend, add 2 ounces of refrigerant oil when replacing
evaporator. Add one ounce when replacing condenser. When replacing
receiver-drier or hoses, add 1/3 ounce per component replaced.
         4) On Integra, add one ounce of refrigerant oil when
replacing evaporator. When replacing condenser, receiver-drier or
hoses, add 1/3 ounce per component replaced.
         5) On Vigor, add 1/2 ounce of refrigerant oil when replacing
evaporator. Add 2/3 ounce when replacing condenser. When replacing
receiver-drier or hoses, add 1/3 ounce per component replaced.

         Chrysler Corp. (Colt Vista/Summit Wagon)
         Add 2 ounces of refrigerant oil when replacing evaporator.
Add one ounce when replacing condenser. When replacing receiver-drier
or hoses, add 1/3 ounce per component replaced.

         Ford Motor Co.
         On Capri, add 2-3 ounces when replacing compressor. Add one
ounce of refrigerant oil when replacing condenser or evaporator. When
replacing receiver-drier, add 1/2 ounce. On Festiva, drain and measure
oil from receiver-drier. Add the amount drained plus one ounce. Add
one ounce when replacing condenser. Add 3 ounces of refrigerant oil
when replacing evaporator.

         Geo, Hyundai & Mazda
         Add one ounce of refrigerant oil when replacing condenser.
Add 1-1 1/2 ounce when replacing evaporator. When replacing receiver-
drier or hoses, add 1/3 ounce per component replaced.

         Lexus & Toyota
         The use of refrigerant recovery/recycling is recommended by
manufacturer. After refrigerant recovery process is completed, the
amount of compressor oil removed must be measured and the same amount
added to A/C system. Add 1 1/2 ounces of refrigerant oil when
replacing condenser. Add 1 1/2 ounces when replacing evaporator. When
replacing receiver-drier or hoses, add1/2 ounce per component
replaced.

         Mercedes-Benz

 

 

 

 

 

 

 

Content   ..  80  81  82  83   ..