|
|
ABS AND TCS 4E-25 SSANGYONG Y200 Install the scan tool and check for any DTCs. Is any DTC set? 2. Disconnect the scan tool. 3. Turn the ignition to ON. Does the lamp illuminate for about 2 seconds, then Is the oil pressure lamp illuminated? 1. Turn the ignition to LOCK. 3. Connect a jumper form terminal 22 to the grounding bar in the connector. 4. Turn the ignition to ON. Does the TCS indicator illuminate? 1. Turn the ignition to LOCK. on both the ABS wiring harness and on the EBCM. Is there a poor connection at any of these terminals? Is the repair complete? Replace the ABS unit. 1. Turn the ignition to LOCK. 2. Disconnect the wire from the negative battery terminal. 3. Measure the resistance between the negative battery wire, which is attached to ground, and the Is the resistance equal to the specified value? Is the repair complete? 1. Remove the I/P cluster. Is the bulb burned out? 2. Replace the I/P cluster. Is the repair complete? Is the continuity equal to the specified value? Is the repair complete? Traction Control System (TCS) Indicator Lamp Inoperative Step 1 Action Yes No Value 2 Go to the DTC table Go to Step 2 - Go to “Intermittent and Poor Connections” Go to Step 3 - 3 Go to Step 4 Go to Step 19 - 4 Go to Step 5 Go to Step 8 - 5 Go to Step 6 Go to Step 7 - 6 7 8 Go to Step 10 Go to Step 9 ≈ 0 Ω 9 System OK - - 10 Go to Step 11 Go to Step 12 - 11 System OK - - 12 Go to Step 14 Go to Step 13 ≈ 0 Ω 13 System OK - - System OK - - System OK - - |