|
|
DI05-10 CHANGED BY EFFECTIVE DATE AFFECTED VIN LUBRICATION SYSTEM DI ENG SM - 2004.4 Y220_05010 ENGINE OIL CHANGE Change interval: Initial change: 5,000 km, Change every 10,000 km or 12 months Engine Oil Changing Procedures 1. Park the vehicle on the level ground and warm up the engine until it reaches normal operating temperature. 2. Stop the engine and wait around 5 minutes. Remove the oil filler cap, oil filter and oil drain plug to drain the oil. 3. Install new oil filter and tighten the drain plug with specified tighten torque. 5. Close the oil filler cap and start the engine. 6. Stop the engine again and check the oil level. Add the engine oil if needed and check for the oil leaks. Oil drain plug 25 ± 2.5 Nm 4. Fill the engine oil through the oil filler opening. Frequently check and add if needed. Shorten the change interval under severe conditions. * Severe condition: - When most trips include extended idling and/or frequent low-speed operation as in stop-and-go traffic. - When most trips are less than 6 km (Operating when outside temperatures remain below freezing and when most trips are less than 16 km) - When operating in dusty, sandy and salty areas - In hilly or moutainous terrain - When doing frequent trailer towing Notice Water separation from the fuel filter should be performed when changing the engine oil. Notice After driving, the engine oil temperature may be high Notice • Over-tightening may cause oil leaks. • Replace the drain plug washer with new one. Notice The oil should not go above the upper mark on the dipstick. This would lead, for example, to increased oil |