|
|
2.8 Deactivating, activating the function Press switch 1 to deactivate the func- tion. The message “Stop & Start deac- tivated” will appear on the instrument panel and the integrated warning light 2 on the switch will light up. Pressing again will reactivate the system. The message “Stop & Start ac- tivated” will appear on the instrument panel and the integrated warning light 2 on the switch 1 will go out. FUNCTION STOP AND START (3/3) Deactivate the Stop and Start function when perfor- ming any operations in the engine compartment. Special feature of the automatic engine re-start can restart on its own in order to gua- rantee your safety and comfort. This can occur especially when: too high (less than around 0 °C or higher than around 30 °C); – the “Clear View” function is activated (please see “Automatic Climate Control” in Section 3); – the battery is not sufficiently char- ged; – the vehicle speed is above 4.34 mph (7 km/h) (downhill slope etc.) ; – repeated pressing on the brake pedal or braking system require- ment; – ... Before getting out of the vehicle, you must switch off the ignition by pressing the engine stop (please see “Starting, stopping the engine”). 1 2 Note: With the engine on standby, press switch 1 to automatically re- start the engine. The system reactivates automati- cally each time the vehicle is started using the start button (please refer to “Starting, stopping the engine” in Section 2). Operating faults When the message “Check Stop & Start” appears on the instrument panel and the integrated warning light 2 lights up on the switch 1, the system is deac- tivated. Please consult an authorised dealer. In the event of an emer- gency, the engine can be restarted by pressing on the clutch pedal if the Stop and Start function is activated. |