|
|
FRONT STABILIZER FSU-13 < REMOVAL AND INSTALLATION > C D F G H I J K L M A B FSU N O P • Install the stabilizer bushing with the slit (A) facing the rear of the vehicle. : Rear • To install stabilizer clamp bolt, temporarily tighten them in numeri- cal order as shown, then tighten them to the specified torque. : Front • To connect the stabilizer connecting rod (1), tighten the nut while holding the hexagonal part (A) on the stabilizer connecting rod. • Perform final tightening of bolts and nuts with the vehicle under unladen conditions with tires on level ground. • Perform inspection after installation. Refer to . Inspection INFOID:0000000009643756 INSPECTION AFTER REMOVAL Check the stabilizer bar, the stabilizer connecting rod, the stabilizer bushing, and the stabilizer clamp for defor- mation, cracks, or damage. Replace components if necessary. INSPECTION AFTER INSTALLATION 1. Check the wheel alignment. Refer to . 2. Perform the steering angle sensor neutral position adjustment. Refer to . JPEIA0273ZZ JPEIA0274ZZ JPEIA0252ZZ |