|
|
AV-180 < BASIC INSPECTION > [NAVIGATION] INSPECTION AND ADJUSTMENT 2. Identify the correct model and configuration list. Refer to AV-180, "CONFIGURATION (AROUND VIEW MONITOR CONTROL UNIT) : Configuration List" . 3. Confirm and/or change setting value for each item. CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct. 4. Select “Next”. CAUTION: Make sure to select “Next”, confirm each setting value and press “OK” even if the indicated con- figuration of brand new around view monitor control unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model can not be memorized. 5. When "Completed", select "End". >> GO TO 4. 4. OPERATION CHECK Confirm that each function controlled by around view monitor control unit operates normally. >> Work End. CONFIGURATION (AROUND VIEW MONITOR CONTROL UNIT) : Configuration List INFOID:0000000009697569 CAUTION: Thoroughly read and understand the vehicle specification. Incorrect settings may result in abnormal control of ECU. ⇔: Items which confirm vehicle specifications PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT INFOID:0000000009697570 Adjust the center position of the predictive course line of the rear view monitor if it is shifted. PREDICTED COURSE LINE CENTER POSITION ADJUSTMENT : Work Procedure INFOID:0000000009697571 1. DRIVING Drive the vehicle straight ahead 100 m (328.1 ft) or more at a speed of 30 km/h (18.6 MPH) or more. >> END CALIBRATING CAMERA IMAGE (AROUND VIEW MONITOR) INFOID:0000000009697572 • Calibration must be performed after removing/replacing the cameras, removing parts (e.g. front grille, door mirror, and others) mounted on the cameras, or replacing the Around view monitor control unit. • The use of CONSULT is required to perform calibration or writing of calibration results to the Around view monitor control unit. • Align the white lines on the road near the vehicle at the boundary of each camera image by this camera cal- ibration. The white lines far from the vehicle may not be aligned at the boundary of each camera image. The farther the line, the greater the difference is. MANUAL SETTING ITEM Items Setting value BCI FUNCTION WITH ⇔ WITHOUT |