|
|
TM-366 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F11A] P0740 TORQUE CONVERTER P0740 TORQUE CONVERTER DTC Logic INFOID:0000000009268167 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1. PREPARATION BEFORE OPERATION (PART 1) If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2. PREPARATION BEFORE OPERATION (PART 2) With CONSULT 1. Start the engine. 2. Select “Data Monitor” in “TRANSMISSION”. 3. Select “FLUID TEMP”. 4. Confirm that the CVT fluid temperature is in the following range. With GST 1. Start the engine. 2. Set the CVT fluid to 10 °C (50°F) or more. NOTE: When the ambient temperature is 20 °C (68°F), the CVT fluid usually increases to 50 to 80°C (122 to 176 °F) with driving in an urban area for approximately 10 minutes. Is the CVT fluid 10 °C (50°F) or more? YES >> GO TO 3. NO >> 1. Warm the transaxle. 2. GO TO 3. 3. CHECK DTC DETECTION 1. Drive the vehicle. 2. Maintain the following conditions for 10 seconds or more. 3. Stop the vehicle. 4. Check the first trip DTC. YES >> Go to NO >> INSPECTION END DTC Trouble diagnosis name DTC detection condition Possible causes P0740 Torque Converter Clutch Cir- The TCM torque converter clutch solenoid more - GND short diagnosis of the solenoid valve circuit is not satisfied. - TCM power supply voltage: More than 11 V • Harness or connector (Torque converter clutch solenoid • Torque converter clutch solenoid valve FLUID TEMP : 10 °C (50°F) or more Selector lever : “D” position Vehicle speed : 40 km/h (25 MPH) or more |