Nissan Pathfinder. Instruction - part 388

DLK-318

< REMOVAL AND INSTALLATION >

BACK DOOR WARNING CHIME

BACK DOOR WARNING CHIME

Removal and Installation

INFOID:0000000009744485

REMOVAL

1. Remove the rear bumper fascia. Refer to 

EXT-20, "Removal and Installation"

.

2. Remove the back door warning chime bracket nut (A) and

remove back door warning chime (1).

3. Remove back door warning chime (1) from bracket (2) (if neces-

sary).

INSTALLATION

Installation is in the reverse order of removal.

ALKIA3219ZZ

REMOTE KEYLESS ENTRY RECEIVER

DLK-319

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

J

L

M

A

B

DLK

N

O

P

REMOTE KEYLESS ENTRY RECEIVER

Removal and Installation

INFOID:0000000009175919

REMOVAL

1. Remove the glove box assembly. Refer to 

IP-26, "Removal and Installation"

.

2. Remove the remote keyless entry receiver bolt. 
3. Disconnect the harness connector from remote keyless entry receiver and remove.

INSTALLATION

Installation is in the reverse order of removal.

DLK-320

< REMOVAL AND INSTALLATION >

INTELLIGENT KEY BATTERY

INTELLIGENT KEY BATTERY

Removal and Installation

INFOID:0000000009175920

1. Release the lock knob on the back of the Intelligent Key and remove the key.

2. Insert a suitable tool (A) wrapped with a cloth into the slit of the

corner and twist it to separate the upper part from the lower part.

CAUTION:

• Do not insert a tool into the notches of the Intelligent Key

to pry it open, as this may damage the circuit board.

• Do not use excessive force when opening the intelligent

key, as this may result in damage to the internal compo-

nents.

• Do not touch the circuit board or battery terminal.

• The key fob is water-resistant. However, if it does get wet,

immediately wipe it dry. 

3. Replace the battery with a new one.

4. Align the tips of the upper and lower parts, and then push them

together until unit is securely closed.

CAUTION:

• When replacing battery, keep dirt, grease, and other for-

eign materials off the electrode contact area.

• After replacing the battery, check that all Intelligent Key

functions work normally.

PIIB6221E

Battery replacement

:Coin-type lithium battery 
(CR2025)

PIIB6222E

AUTOMATIC BACK DOOR CONTROL MODULE

DLK-321

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

J

L

M

A

B

DLK

N

O

P

AUTOMATIC BACK DOOR CONTROL MODULE

Removal and Installation

INFOID:0000000009175921

REMOVAL

1. Remove the luggage side lower finisher (LH). Refer to 

INT-31, "LUGGAGE SIDE LOWER FINISHER :

Removal and Installation"

.

2. Remove the automatic back door control module bolts. 
3. Disconnect the harness connector from the automatic back door control module and remove.

INSTALLATION

Installation is in the reverse order of removal.