-17
Power steering fluid
When to check the power steering fluid
The power steering stock solution tank
is in the front of the engine cabin beside
the vehicle passengers. See 野General
Drawing of Engine Cabin冶 in this section
to confirm the position of the stock solu鄄
tion tank.
Unless you doubt that there is leakage
in the system or you have heard abnor鄄
mal sound, it is unnecessary to inspect
the power steering fluid. The run away
of the power steering fluid shows that
there is failure, and it is required to
check and repair the system.
How to inspect the power steering fluid?
Inspect the power steering fluid as the
following steps:
1. Cut off the ignition switch and wait
the engine cabin to be cool.
2. Wipe clean the tank cover and the
surface of the stock solution tank.
3. Unscrew the tank cover.
4. Add power steering fluid to the prop鄄
er level.
Mount the tank cover again and screw
tightly completely.
The level shall be between the upper
limit MAX mark and lower limit of the
stock solution tank.
If the level falls to or below the lower
limit MIN mark position, add power
steering fluid to make the level rise to
the upper limit MAX position.
MO TORS
You can remove the coolant expansion
pot cover after the cooling system, in鄄
cluding coolant expansion pot cover
and radiator hose, cools down.
Add proper mixture to the coolant ex鄄
pansion pot till it reaches the upper limit
mark of the expansion pot. Wait for 5
minutes, and check whether the fluid
level is lower than the upper limit mark.
If the fluid level is lower than the upper
limit mark, raise the level to the upper
limit position by adding some coolant
again. Repeat this step to keep the level
at the upper limit position for at least 5
minutes.
Do not cover the expansion pot cover
and start the engine to let it run until you
can feel the upper radiator hose be鄄
come hot. Be careful not to touch the
cooling fan. At this time, the coolant lev鄄
el in the expansion pot will fall; add
more mixture to the expansion pot to
make the level reach the upper limit
mark position if the level is lower than
the upper limit mark. Then cover the
cover and make sure the cover is
mounted in place.
Main fluid parameters
It is suggested to use the following
coolant specification.
Notes
When the weather is cold, the water will
cause the engine, radiator and other
components to become frost cleft. So,
please use the recommended coolant
and proper coolant mixture.
-16
Name
Brand
Volume
Engine
coolant
43/57 proportioned anti -
freezing solution at -45益
7L