Ford C-MAX Hybrid / Energi (2016 year). Manual - part 25

Action

Message

Your vehicle enables the engine due to the climate control
defrost setting. This is normal operation.

Engine Enabled Due to

Defrost Setting

Your vehicle enables the engine for system performance. This
is normal operation.

Engine Enabled for

System Performance

You can press OK to enable the engine temporarily for
increased performance when in EV Now mode.

Press OK to Enable

Engine

Doors

Action

Message

Displays when the door(s) listed is not completely closed and
the vehicle is moving.

X Door Ajar

Displays when the door(s) listed is not completely closed.

Displays when the liftgate is not completely closed.

Liftgate Ajar

Fuel

Action

Message

An early reminder of a low fuel condition.

Fuel Level Low

EV functionality is disabled and the engine is running to
maintain fuel freshness. See Fuel Quality (page 144).

Fuel Freshness Engine

may run to maintain fuel

freshness

Wait for up to 15 seconds while the fuel system depressurizes.

Fuel Door Opening

The fuel system has finished depressurizing and you can begin
to refuel.

Fuel Door Open

A reminder to close the fuel door.

Close Fuel Door

There is an error in attempting to refill your vehicle.

Refuel Error See Manual

Hill Start Assist

Action

Message

Displays when hill start assist is not available. Contact your
authorized dealer.  See Hill Start Assist (page 165).

Hill Start Assist Not

Available

Keys and Intelligent Access

Action

Message

This message is displayed when there is a problem with your
vehicle’s starting system. See your authorized dealer for
service.

Starting System Fault

Displays to remind you that the key is in the luggage
compartment.  See Plug-In Hybrid Vehicle Operation (page
137).

Key Inside vehicle

Displays if the key is not detected by the system.  See Plug-
In Hybrid Vehicle Operation (page 137).

Key Not Inside vehicle

Displayed if the key is not detected by the system.  See Plug-
In Hybrid Vehicle Operation (page 137).

No Key Detected

Displayed when the start/stop button is pressed to shut off
the engine and a Intelligent Access Key is not detected inside
the vehicle.

Restart Now or Key is

Needed

Displayed when the vehicle is in the Accessory ignition state.

Accessory Power is

Active

Displayed as a reminder to press the brake while starting the
vehicle.

To START Press Brake

Displayed as a reminder to apply the brake and push the start
button to start the vehicle.

Press Brake + Start

Button

Displayed as needed by the system for proper function.

Place Key in Backup

Location

Displayed during spare key programming, when an intelligent
access key is programmed to the system.

Key Programmed x Keys

Total

Displayed during spare key programming when the maximum
number of keys have been programmed.

Max Number of Keys

Learned

Displayed when an attempt is made to program a spare key
using two existing MyKeys.

Could Not Program

Integrated Key

Maintenance

Action

Message

Stop the vehicle as soon as safely possible, turn off the engine.
Check the oil level. If the warning stays on or continues to
come on with your engine running, contact your authorized
dealer as soon as possible.

Low Engine Oil Pressure

Displayed when the engine oil life remaining is 10% or less.
See Engine Oil Check (page 222).

Change Engine Oil Soon

Displayed when the oil life left reaches 0%.  See Engine Oil
Check (page 222).

Oil Change Required

Indicates the brake fluid level is low and the brake system
should be inspected immediately.  See Brake Fluid Check
(page 227).

Brake Fluid Level Low

Displays when the brake system needs servicing. Stop the
vehicle in a safe place. Contact your authorized dealer.

Check Brake System

Displays when the engine coolant temperature is excessively
high.

Engine Coolant Over

Temperature

Displays when the motor coolant temperature is excessively
high.

Motor Coolant Over

Temperature

Displayed when the kit needs service. See your authorized
dealer.

Service Tire Mobility Kit

Informs the driver that the powertrain needs service due to a
powertrain malfunction.

See Manual

Displays when EV functionality is disabled and the engine is
running to maintain oil quality.  See Plug-In Hybrid Vehicle
Operation (page 137).

Engine ON Due to Low
Use Normal Operation

MyKey

Action

Message

Displayed during key programming when MyKey cannot be
programmed.

MyKey not Created

Displays when MyKey is active.

MyKey Active Drive

Safely

Displays when a MyKey is in use and the MyKey speed limit is
on and the vehicle speed is approaching 80 mph (130 km/h).

Near Vehicle Top Speed

Action

Message

Displays when a MyKey is in use and the MyKey speed limit is
reached.

Vehicle at Top Speed of

MyKey Setting

Displays when MyKey is active.

Check Speed Drive

Safely

Displays when a MyKey is in use and Belt-Minder is activated.

Buckle Up to Unmute

Audio

Displays when a MyKey is in use and Traction control is
activated.

Traction Control On -

MyKey Setting

Displays when a MyKey is in use and park aid is activated.

MyKey Park Aid Cannot

be Deactivated

Park Aid

Action

Message

Displays when the system has detected a condition that
requires service. Contact your authorized dealer.  See Prin-
ciple of Operation (page 170).

Check Park Aid

Displays the park aid status.

Rear Park Aid On Off

Displays when the system has detected a condition that
requires attention.  See Principle of Operation (page 170).

Check Rear Park Aid

Displays when the system has detected a condition that
requires attention.  See Principle of Operation (page 170).

Check Front Park Aid

Displays when the system has detected a condition that
requires service. Contact your authorized dealer.  See Prin-
ciple of Operation (page 170).

Park Aid Fault

Park Brake

Action

Message

Displays when the parking brake is set, the engine is running
and the vehicle is driven more than 3 mph (5 km/h). If the
warning stays on after the parking brake is released, contact
your authorized dealer.

Park Brake Engaged