TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance of the Cinch/Release Motor Latch Driver circuit between the
Sliding Door Control Module C2 connector and the Cinch/Release Motor connector.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 4
No
→ Repair the Cinch/Release Motor Latch Driver wire for an open.
Perform BODY VERIFICATION TEST - VER 1.
4
Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance of the Cinch/Release Motor Unlatch Driver circuit between
the Sliding Door Control Module C2 connector and the Cinch/Release Motor connec-
tor.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 5
No
→ Repair the Cinch/Release Motor Unlatch Driver wire for an open.
Perform BODY VERIFICATION TEST - VER 1.
5
Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance between ground and the Cinch/Release Motor Latch Driver
circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 1000.0 ohms?
All
Yes
→ Go To 6
No
→ Repair the Cinch/Release Motor Latch Driver wire for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
6
Turn the ignition off.
Disconnect the Sliding Door Control Module C2 connector.
Disconnect the Cinch/Release Motor connector.
Measure the resistance between ground and the Cinch/Release Motor Unlatch Driver
circuit.
Wiggle the harness and check for an intermittent open condition.
Is the resistance below 1000.0 ohms?
All
Yes
→ Go To 7
No
→ Repair the Cinch/Release Motor Unlatch Driver wire for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
7
If there are no possible causes remaining, view repair.
All
Repair
Replace the Latch Assembly.
Perform BODY VERIFICATION TEST - VER 1.
867
POWER DOORS - SLIDING
INCOMPLETE LATCH CINCH - OVERCURRENT —
Continued