TEST
ACTION
APPLICABILITY
7
Turn the ignition off.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Liftgate Cinch/Release Motor connector.
Measure the resistance between ground and the Liftgate Latch Release Driver
circuit.
Wiggle the harness and check for an intermittent short condition.
Is the resistance below 1000.0 ohms?
All
Yes
→ Go To 8
No
→ Repair the Liftgate Latch Release Driver wire for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
8
Turn the ignition off.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Liftgate Cinch/Release Motor connector.
Measure the resistance between the Ground circuit (cavity 20) and the Liftgate Latch
Release Driver circuit.
Wiggle the harness and check for an intermittent short condition.
Is the resistance below 1000.0 ohms?
All
Yes
→ Go To 9
No
→ Repair the Liftgate Latch Release Driver wire for a short to the
Ground circuit.
Perform BODY VERIFICATION TEST - VER 1.
9
If there are no possible causes remaining, view repair.
All
Repair
Replace the Latch Assembly.
Perform BODY VERIFICATION TEST - VER 1.
807
POWER DOORS - LIFTGATE
INCOMPLETE LATCH CINCH - OVERCURRENT —
Continued