|
|
1. With the scan tool perform the Steering Angle Sensor Calibration. 2. Operate the vehicle within the conditions for setting the DTC. Verify DTC C0186, C0196, C0253, or C0710 are not set. If DTC C0186, C0196, or C0710 are set, refer to Diagnostic Trouble Code (DTC) If only DTC C0253 set, replace the yaw and lateral acceleration sensor. If DTC C0253 sets Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement Control Module References for EBCM replacement, setup, and programming DTC C0299 Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptor DTC C0299 00 Brake Booster Sensor Performance DTC C0299 5A Brake Booster Sensor Plausibility Failure DTC C0299 31 Brake Booster General Checksum Failure Diagnostic Fault Information Short to Open/High Short to Signal
2008 Chevrolet Silverado 1500 2008 BRAKES Antilock Brake System - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|