2.2
Output Shaft, Disassembling and As‐
sembling
⇒ “2.2.1 Output Shaft, Disassembling and Assembling, 1st to 4th
Gears”, page 172
⇒ “2.2.2 Output Shaft, 5th, 6th and Reverse Gears, Disassem‐
bling and Assembling”, page 182
2.2.1
Output Shaft, Disassembling and As‐
sembling, 1st to 4th Gears
Special tools and workshop equipment required
♦ Press Plate - VW401-
♦ Press Plate - VW402-
♦ Press Piece - Rod - VW407-
♦ Press Piece - Rod - VW408A-
♦ Press Piece - Multiple Use - VW412-
♦ Press Piece - 60mm - VW415A-
♦ Holding Plate - VW309A-
♦ Holding Fixture - VW313-
♦ Transmission Support - VW353-
♦ Press Piece - Multiple Use - VW431-
♦ Press Piece - Multiple Use - VW433-
♦ Press Piece - Multiple Use - VW454-
♦ Press Piece - Multiple Use - VW512-
♦ Press Piece - 42mm - VW516-
♦ Press Piece - Multiple Use - VW519-
♦ Slide Hammer Set - VW771-
♦ Crankshaft Holding Fixture - VW801-
♦ Press Piece - Multiple Use - 40-105-
♦ Bearing Installer - Multiple Use - 40-20-
♦ Bearing Installer - Differential Bearing - 40-21-
♦ Press Piece - Multiple Use - 2050-
♦ Holding Fixture - Spacers - VW540/1B-
♦ Puller - Taper Roller Bearing - VAG1582-
♦ Puller - Taper Roller Bearing - Adapter 7 - VAG1582/7-
♦ Inductive Heater - VAS6414-
♦ Puller - Kukko Internal - 46-56mm - 21/7-
♦ Puller - Kukko Internal - 56-70mm - 21/8-
♦ Puller - Kukko Puller - 60-200mm Width, 250mm Length -
18/2-
♦ Puller - Kukko Quick Action Separating Tool - 22-115mm -
17/2-
♦ Puller - Kukko Counterstay - 22/2-
Removing the Dished Washer -A- from the Output Shaft