Volkswagen Golf / Golf GTI / Golf Variant. Service manual - part 287

– Remove the glass panel. Refer to

– Remove the glass panel if the drive motor is defective. Refer

– Remove the self-adhesive insulation -3-.
– Remove the bolts -2-.
– Remove the cover -1- upward at an angle in direction of

-arrows-.

– Remove the screws -3- and then remove the handle -4-.

– Remove the screws -5-.

Note

♦

If the sun shade is reused, make sure that the steel bands are not bent.

♦

If a steel band is bent, then a new sun shade must be installed.

– Lift the sun shade -1- left and right at the rear in direction of

-arrow a- and push evenly rearward in direction of -arrow b-,

the pull from the guide rails -2-.

– Push the slider -3- into the bow in direction of -arrow c- and

remove it from the guide in direction of -arrow d-.

– Remove the sun shade -1- from the sunroof frame.
When it is necessary for further work, the tension bow can be

removed from the sun shade. Refer to

Installing

Note

♦

When installing the sun shade, make sure that the steel bands are not bent.

♦

If a steel band is bent, then a new sun shade must be installed.

– Install the right and left yoke -2- into the guide rails -3- in di‐

rection of -arrow a-.

– Make sure the upper in direction of -arrow b- and lower in di‐

rection of -arrow c- yokes are positioned correctly on the guide

rail.

– Push the slider -2- in the guide in direction of -a arrows-.