Volkswagen Golf / Golf GTI / Golf Variant. Service manual - part 274

Caution

A visual inspection when the sliding sunroof is open on the

vehicle is essential to order the correct replacement part. Refer

to 

⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193

Removing

Note

♦

For clarity the headliner is not shown in the illustration..

♦

The headliner is not removed.

♦

The bolts in the inner section are slightly covered by a rubber strip -2-.

♦

Do not damage the rubber strip -2-.

– Open the sun shade all the way.
– Tilt the Panorama tilting sunroof glass panel open.
– Remove the center bolts on the inside -arrows-.

– Open the Panorama tilting sunroof glass panel -arrow A-.
– Remove the rear bolts -arrow-.
– Remove the inner front bolts on the left and right side

-arrow-.

– Only loosen the outer front bolts on the left and right side

-arrow-.

– Remove the glass panel -1- upward.

Note

Close the mechanism with the button in order to avoid damage during further work.

Installing

Note

Screws are microencapsulated and must always be replaced after removing.

Open the mechanism with the button.
– Position the glass panel -1- on the tilting mechanism -2-.
– Only tighten the front and rear bolts -arrows- slightly.

Tilt the Panorama tilting sunroof glass panel open.
– Only tighten the center bolts -arrows- on the left and right side

slightly.

– Adjust the Panorama tilting sunroof glass panel (height ad‐

justment). Refer to

⇒ “1.8 Glass Panel, Adjusting”, page 241

 .

Note

Tighten the bolts after the panel height adjustment.

Tightening Specifications
♦ Refer to

⇒ “1.2.2 Overview - Sunroof, Sedan from 03/2015”,

page 197