Volkswagen Corrado (1993 year). Manual - part 206

 

  Index      Volkswagen     Volkswagen Corrado - service repair manual 1993 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  204  205  206  207   ..

 

 

Volkswagen Corrado (1993 year). Manual - part 206

 

 

TROUBLE SHOOTING - BASIC PROCEDURES 

BASIC STARTER TROUBLE SHOOTING CHART

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

CONDITION          POSSIBLE CAUSE             CORRECTION

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Fails      Dead battery or bad        Check battery charge
to Operate         connections between        and all wires and
                   starter and battery        connections to starter

                   Ignition switch faulty     Adjust or replace
                   or misadjusted             ignition switch

                   Open circuit between       Check and repair wires
                   starter switch ignition    and connections as
                   terminal on starter relay  necessary

                   Starter relay or starter   See Testing in STARTER
                   defective                  article

                   Open solenoid pull-in      See Testing in STARTER
                   wire                       article

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Does Not   Weak battery or dead       Charge or replace 
Operate and        cell                       battery as necessary
Headlights Dim
                   Loose or corroded battery  Check that battery
                   connections                connections are clean
                                              and tight

                   Internal ground in         See Testing in STARTER
                   starter windings           article

                   Grounded starter fields    See Testing in STARTERS

                   Armature rubbing on pole   See STARTER article
                   shoes

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Turns      Starter clutch slipping    See STARTER article
but Engine
Does Not Rotate
                   Broken clutch housing      See STARTER article

                   Pinion shaft rusted or     See STARTER article
                   dry

                   Engine basic timing        See Ignition Timing in
                   incorrect                  TUNE-UP article

                   Broken teeth on engine     Replace flywheel and
                   flywheel                   check for starter pinion
                                              gear damage

TROUBLE SHOOTING - BASIC PROCEDURES 

Starter Will Not   Faulty overrunning         See STARTER article
Crank Engine       clutch

                   Broken clutch housing      See STARTER article

                   Broken flywheel teeth      Replace flywheel and
                                              check for starter pinion
                                              gear damage

                   Armature shaft sheared     See STARTER article
                   or reduction gear teeth
                   stripped

                   Weak battery               Charge or replace
                                              battery as necessary

                   Faulty solenoid            See On-Vehicle Tests in
                                              STARTER article

                   Poor grounds               Check all ground
                                              connections for
                                              tight and clean
                                              connections

                   Ignition switch faulty     Adjust or replace
                   or misadjusted             ignition switch as
                                              necessary

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Cranks     Battery weak or            Charge or replace
Engine Slowly      defective                  battery as necessary

                   Engine overheated          See ENGINE COOLING
                                              SYSTEM article

                   Engine oil too heavy       Check that proper
                                              viscosity oil
                                              is used

                   Poor battery-to-starter    Check that all
                   connections                between
                                              battery and starter are
                                              clean and tight

                   Current draw too low or    See Bench Tests in
                   too high                   STARTER article

                   Bent armature, loose pole  See STARTER article
                   shoes screws or worn
                   bearings

                   Burned solenoid contacts   Replace solenoid

TROUBLE SHOOTING - BASIC PROCEDURES 

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Engages    Engine timing too far      See Ignition Timing in
Engine Only        advanced                   TUNE-UP article
Momentarily
                   Overrunning clutch not     Replace overrunning
                   engaging properly          clutch. See STARTER
                                              article

                   Broken starter clutch      See STARTER article

                   Broken teeth on engine     Replace flywheel and
                   flywheel                   check starter pinion
                                              gear for damage

                   Weak drive assembly        See STARTER article
                   thrust spring

                   Weak hold-in coil          See Bench Tests in
                                              STARTER article

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Drive      Defective point assembly    See Testing in STARTER
Will Not Engage                                article

                   Poor point assembly ground  See Testing in STARTER
                                               article

                   Defective pull-in coil      Replace starter
                                               solenoid

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Relay      Dead battery                Charge or replace
Does Not Close                                 battery as necessary

                   Faulty wiring               Check all wiring and
                                               connections leading to
                                               relay

                   Neutral safety switch       Replace neutral safety
                   faulty                      switch

                   Starter relay faulty        Replace starter relay

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Drive      Starter motor loose on      Tighten starter
Will Not           mountings                   attach bolts
Disengage
                   Worn drive end bushing      See STARTER article

                   Damaged engine flywheel     Replace flywheel and
                   teeth                       starter pinion gear for
                                               damage

TROUBLE SHOOTING - BASIC PROCEDURES 

                   Faulty ignition switch      Replace ignition switch

                   Insufficient clearance      Replace starter
                   between winding leads to    solenoid
                   solenoid terminal and main
                   contact in solenoid

                   Starter clutch not          Replace starter clutch
                   disengaging

                   Ignition starter switch     Replace ignition switch
                   contacts sticking

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Starter Relay      Faulty solenoid switch,     Check all wiring
Operates but       switch connections or       between relay and
Solenoid Does Not                              solenoid or replace
                                               relay or solenoid as
                                               necessary

                   Broken lead or loose        Repair wire or wire
                   soldered connections        connections as
                                               necessary

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Solenoid Plunger   Weak battery                Charge or replace
Vibrates When                                  battery as necessary
Switch is Engaged
                   Solenoid contacts           Clean contacts or
                   corroded                    replace solenoid

                   Faulty wiring               Check all wiring
                                               leading to solenoid

                   Broken connections inside   Repair connections or
                   switch cover                replace solenoid

                   Open hold-in wire           Replace solenoid

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Low Current Draw   Worn brushes or weak        Replace brushes or
                                               brush springs as
                                               necessary

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

High Pitched Whine Distance too great          Align starter or check
During Cranking    between starter             that correct starter
Before Engine      pinion and flywheel         and flywheel are being
Fires but Engine                               used
Fires and Cranks
Normally

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

High Pitched       Distance too small between

 

 

 

 

 

 

 

Content   ..  204  205  206  207   ..