Volkswagen Corrado (1993 year). Manual - part 181

 

  Index      Volkswagen     Volkswagen Corrado - service repair manual 1993 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  179  180  181  182   ..

 

 

Volkswagen Corrado (1993 year). Manual - part 181

 

 

SCHEDULED SERVICES 

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

END OF ARTICLE

SPECIFICATIONS & ELECTRIC COOLING FANS 

         1993 ENGINE COOLING
         Volkswagen Specifications & Electric Cooling Fans

         Volkswagen;  Corrado SLC, Passat

         SPECIFICATIONS

         BELT ADJUSTMENT

BELT ADJUSTMENT TABLE

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Application                                    Specification

A/C Compressor
 Passat GL
 New  ............................  (1) 72 INCH Lbs. (8 N.m)
 Used  ...........................  (1) 36 INCH Lbs. (4 N.m)
Alternator
 Passat GL  ..................  (1) (2) 72 INCH Lbs. (8 N.m)
Power Steering
 Passat GL  .................................  13/64" (5 mm)
Serpentine Belt
 Corrado SLC, Passat GLX  .............................  (3)

(1) - Turn tensioning nut on toothed rack with Torque Wrench
      (VAG1410) and Ring Insert (SW VAG 1410-2).
(2) - Start engine and let it idle for 5 minutes. Loosen
      bolts and retighten belt to specification.
(3) - Serpentine belt tension automatically adjusted by
      tensioner.

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

         COOLING SYSTEM SPECIFICATIONS

COOLING SYSTEM SPECIFICATIONS (1)

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Model                                          Specification

Coolant Replacement Interval  ................  30,000 Miles
 Corrado SLC  .............................  9.1 Qts. (8.6L)
 Passat GL  ...............................  5.9 Qts. (5.6L)
 Passat GLX  ..............................  9.1 Qts. (8.6L)

(1) - Cooling system includes heater.

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

         ELECTRIC COOLING FAN

NOTE:    If detonation is a problem, it is possible that the cooling

SPECIFICATIONS & ELECTRIC COOLING FANS 

         Corrado SLC, Passat GLX
         The cooling fan is either a 1 or 2-speed motor. If vehicle is
equipped with single-speed motor, the fan comes on at 198-207

ø

F (92-

97

ø

C) and turns off at 183-196

ø

F (84-91

ø

C). If equipped with a 2-speed

motor, low speed of cooling fan should come on at 198-208

ø

F (92-98

ø

C)

on vehicles without A/C, or 183-207

ø

F (84-97

ø

C) on vehicles with A/C.

Low speed will shut off at 183-196

ø

F (84-91

ø

C) on all vehicles. High

speed comes on at 210-226

ø

F (99-108

ø

C) on vehicles without A/C, or

201-226

ø

F (94-108

ø

C) on vehicles with A/C. High speed will shut off at

196-220

ø

F (91-104

ø

C) on all vehicles.

         After-Run Thermoswitch
         An after-run switch is used to help prevent fuel
vaporization. The thermoswitch turns cooling fan on when temperatures
in engine compartment exceeds 230

ø

F (110

ø

C), and turns it off at 217

ø

F

(103

ø

C).

         Passat GL
         The cooling fan is a 2-speed motor. Low speed of cooling fan
should come on at 198-207

ø

F (92-97

ø

C) and will shut off at 183-196

ø

F

(84-91

ø

C). High speed comes on at 210-221

ø

F (99-105

ø

C) and will shut

off at 196-208

ø

F (91-98

ø

C).

         TROUBLE SHOOTING

NOTE:    Trouble shooting information not available from manufacturer.

         TESTING

         ENGINE COOLANT TEMPERATURE (ECT) SENSOR

         Corrado SLC & Passat GLX (2.8L)
         1) Ensure engine is cold. Connect Scan Tester (VAG 1551) to
Data Link Connectors (DLC) located in center console, in front of
shift lever.
         2) Start engine and allow it to idle. With scan tester in
READ TEST VALUE BLOCK function, select group No. 01 and read coolant
temperature value in field No. 2 of scan tester. Temperature value
must increase uniformly without interruption. If value increases as
specified, select END OUTPUT function on scan tester.
         3) If displayed value does not change or if engine
malfunctions during certain temperature ranges, turn ignition off and
measure engine coolant temperature sensor resistance. See ECT SENSOR
LOCATION table. Replace ECT sensor if resistance is not within
specification. See ECT SENSOR RESISTANCE table.

         Passat GL
         1) Ensure engine is cold. Connect Scan Tester (VAG 1551) to
Data Link Connectors (DLC) located in center console. Start engine and

SPECIFICATIONS & ELECTRIC COOLING FANS 

ECT SENSOR RESISTANCE TABLE

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Temperature 

ø

F (

ø

C)                                     Ohms

68 (20)  ........................................  3000-2000
86 (30)  ........................................  2000-1500
104 (40)  .......................................  1500-1000
122 (50)  ........................................  1000-800
140 (60)  .........................................  700-500
158 (70)  .........................................  500-375
176 (80)  .........................................  375-275
194 (90)  .........................................  275-225

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

ECT SENSOR LOCATION TABLE

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

Model                                               Location

Corrado SLC & Passat GLX
 Blue, Brown & Yellow Sensor  .  On Radiator Near Upper Hose
Passat GL  ..............................  Below Distributor

ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

END OF ARTICLE

 

 

 

 

 

 

 

Content   ..  179  180  181  182   ..