|
|
it in, and the connector (tongue) plate will disconnect from the buckle. 2. With the belt held by hand, allow the retractor to roll up the belt slowly. You should hold the webbing end and guide it back into the retractor while it is rolling up. Neatly store the tongue plate in the recess on the ceiling and then insert the con- nector (tongue) plate into the slot located at the front of the recess. CAUTION . Do not allow the retractor to roll up the seatbelt too quickly. Otherwise, the metal tongue plates may hit against the trim, resulting in damaged trim. . Have the seatbelt fully rolled up so that the tongue plates are neatly stored. A hanging tongue plate can swing and hit against the trim during driving, causing damage to the trim. ! Third-row seatbelt belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving a strong pull on it, then pull it out slowly again. 3. Insert the tongue plate into the buckle until you hear a click. Seat, seatbelt and SRS airbags 1-25 – CONTINUED – |