|
|
SSANGYONG Y200 5D2-36 TRANSFER CASE - TOD TP Sensor Loss of Signal Circuit Description The transfer case control unit (TOD) receives throttle Conditions for Setting the DTC The transfer case control unit (TOD) can not receive • TOD is malfunction. • ECM is malfunction. DIAGNOSTIC TROUBLE CODE (DTC) 1715 Action Taken When the DTC Sets The TOD will illuminates 4WD CHECK indicator and Diagnostic Aids • Check for poor connections of CAN bus line. • Check for ECM and TP sensor. Test Description The number(s) below refer to step(s) on the diagnostic 2. This step decides the causal parts of the problem. 4. This step checks the ground condition. 6. This step checks the connection status. Yes Go to Step 2 Go to “TOD Diagnostic System Refer to Section Engine Go to Step 5 System OK No Go to “TOD Diagnostic System Go to Step 3 Go to Step 4 - Value - - 0 Ω - Step 1 2 3 4 Action Was the TOD Diagnostic System Check performed? 1. Turn the ignition switch to OFF. 2. Connect the scan tool to data link connector (DLC) and follow the directions given in the scan tool 3. Turn the ignition switch to ON and request engine DTC. Are there any engine DTC related throttle position (TP) 1. Turn the ignition switch to OFF. case control unit (TOD). 3. Disconnect the gray connector from engine control module (ECM). 4. Connect a digital ohmmeter between the following TOD connector terminal and gray ECM connector • B11 (TOD) and 37 (ECM) • B10 (TOD) and 38 (ECM) • B11 (TOD) and 24 (ECM) • B10 (TOD) and 23 (ECM) Does the resistance of the all circuits measure within the Repair or replace any open wires, faulty connector, or Is the repair complete? |