|
|
|
Content .. 2915 2916 2917 2918 ..
SUPPLEMENTAL RESTRAINT SYSTEM 9J–21 THROUGHOUT THIS ENTIRE DEPLOYMENT AND 9. Twist together one connector wire lead to one deployment wire. The connection should be 10. Bend twisted connection made in the previous step flat and wrap tightly with electrical tape to insulate and 11. Twist together, bend and tape the remaining connector wire lead to the remaining deployment 12. Connect the deployment harness to the driver air bag assembly, yellow 2–pin connector at the base of the WARNING: DEPLOYMENT WIRES SHALL REMAIN THE AIR BAG ASSEMBLY WILL IMMEDIATELY CONNECTING THE DEPLOYMENT WIRES TO THE FAILURE TO FOLLOW PROCEDURES IN THE 13. Disconnect passenger air bag assembly, yellow 2–pin connector located behind glove box assembly. 14. Cut the passenger air bag assembly harness connector from the vehicle leaving at least 15 cm (six 15. Strip 13 mm (1/2 inch) of insulation from blue–white and pink–blue wire lead of the connector. 16. Cut two 900 cm (30 feet) deployment wires from 0.8 mm @ (18 gauge) or thicker multi–strand wire. These wires will be used to fabricate the passenger 17. Strip 13 mm (1/2 inch) of insulation from both ends of the wires cut in the previous step. 18. Short the wires by twisting together one end from each. Deployment wires shall remain shorted and not WARNING: FAILURE TO FOLLOW PROCEDURES IN 19. Twist together one connector wire lead to one deployment wire. The connection should be 20. Bend twisted connection made in the previous step flat and wrap tightly with electrical tape to insulate and 21. Twist together, bend and tape the remaining connector wire lead to the remaining deployment 22. Connect the deployment harness to the passenger air bag assembly, yellow 2–pin connector located behind WARNING: DEPLOYMENT WIRES SHALL REMAIN 23. Verify that the inside of the vehicle and the area surrounding the vehicle are clear of all people and 24. Stretch the driver and passenger deployment harness to their full length. 25. Completely cover windshield area and front door window openings with a drop cloth, blanket or similar 26. Notify all people in the immediate area that you intend to deploy the air bags. The deployment will be 27. Separate the two ends of the driver deployment harness wires. WARNING: DEPLOYMENT WIRES SHALL REMAIN NOTE: When the air bag deploys, the rapid gas |