|
|
PRECAUTIONS SRC-79 < PRECAUTION > C D E F G I J K L M A B SRC N O P PRECAUTION PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT INFOID:0000000009882928 The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted. Information necessary to service the system safely is included in the SR and SB section of this Service Man- ual. WARNING: • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer. • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section. • Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Instruction. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har- ness connectors. PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: • When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni- tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury. • When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service. Precaution for SRS "AIR BAG" and "SEAT BELT PRE-TENSIONER" Service INFOID:0000000009882929 • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Instruction. • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 min- utes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre- tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. • The air bag diagnosis sensor unit must always be installed with the arrow mark “ ⇐” pointing toward the front of the vehicle for proper operation. Also check air bag diagnosis sensor unit for cracks, deformities or rust before installation and replace as required. • The spiral cable must be aligned with the neutral position since its rotations are limited. Do not attempt to turn steering wheel or column after removal of steering gear. • Handle air bag module carefully. Always place driver and front passenger air bag modules with the pad side facing upward and seat mounted front side air bag module standing with the stud bolt side facing down. • Conduct self-diagnosis to check entire SRS for proper function after replacing any components. • After air bag inflates, the front instrument panel assembly should be replaced if damaged. Occupant Classification System Precaution INFOID:0000000009882930 Replace occupant classification system control unit and passenger front seat cushion as an assembly. |