|
|
PCS-10 < SYSTEM DESCRIPTION > [IPDM E/R (WITH I-KEY)] DIAGNOSIS SYSTEM (IPDM E/R) DIAGNOSIS SYSTEM (IPDM E/R) Diagnosis Description INFOID:0000000009578954 AUTO ACTIVE TEST Description In auto active test, the IPDM E/R sends a drive signal to the following systems to check their operation. • Front wiper (LO, HI) • Parking lamp • License plate lamp • Tail lamp • Front fog lamp • Headlamp (LO, HI) • A/C compressor (magnet clutch) • Cooling fan Operation Procedure NOTE: Never perform auto active test in the following conditions. • Passenger door is open • CONSULT is connected operation) NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand. 2. Turn the ignition switch OFF. ignition switch OFF. 4. Turn the ignition switch ON within 10 seconds. After that the horn sounds once and the auto active test starts. 5. After a series of the following operations is repeated 3 times, auto active test is completed. • When auto active test has to be cancelled halfway through test, turn the ignition switch OFF. • When auto active test is not activated, door switch may be the cause. Check door switch. Refer to Inspection in Auto Active Test When auto active test is actuated, the following operation sequence is repeated 3 times. Operation se- quence Inspection location Operation 1 Front wiper LO for 5 seconds → HI for 5 seconds 2 • Parking lamp 10 seconds 3 Headlamp LO for 10 seconds →HI ON ⇔ OFF 5 times 4 A/C compressor (magnet clutch) ON ⇔ OFF 5 times 5 Cooling fan LO for 5 seconds → MID for 3 seconds → HI for 2 seconds |