|
|
WW-30 < DTC/CIRCUIT DIAGNOSIS > FRONT WIPER MOTOR LO CIRCUIT FRONT WIPER MOTOR LO CIRCUIT Component Function Check INFOID:0000000009269562 1. CHECK FRONT WIPER LO OPERATION IPDM E/R AUTO ACTIVE TEST 1. Start IPDM E/R auto active test. Refer to PCS-9, "Diagnosis Description" 2. Check that the front wiper operates on LO operation. CONSULT ACTIVE TEST 1. Select FR WIPER of BCM (WIPER) active test item. 2. Check front wiper operation. Is the inspection result normal? YES >> Front wiper motor LO circuit is normal. NO >> Refer to . Diagnosis Procedure INFOID:0000000009269563 Regarding Wiring Diagram information, refer to . 1. CHECK FRONT WIPER MOTOR FUSE 1. Turn the ignition switch OFF. 2. Check that the following fuse is not blown. Is the fuse blown? YES >> Replace the fuse after repairing the affected circuit. NO >> GO TO 2 2. CHECK FRONT WIPER MOTOR (LO) OUTPUT VOLTAGE 1. Turn the ignition switch ON. 2. Select FR WIPER of BCM (WIPER) active test item. 3. While performing the active test, check voltage between IPDM E/R harness connector and ground. Is the inspection result normal? YES >> GO TO 3 NO >> Replace IPDM E/R. Refer to PCS-56, "Removal and Installation" 3. CHECK FRONT WIPER MOTOR (LO) OPEN CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect IPDM E/R and front wiper motor. 3. Check continuity between IPDM E/R harness connector and front wiper motor harness connector. LO : Front wiper (LO) operation OFF : Front wiper OFF Component Capacity Fuse No. Location Front wiper motor 30 A 39 IPDM E/R Terminals FRONT WIPER Voltage (Approx.) (+) (-) IPDM E/R Ground Connector Terminal E45 17 LO Battery voltage OFF 0V |