Nissan Versa Sedan. Instruction - part 835

TM-246

< REMOVAL AND INSTALLATION >

[4AT: RE4F03C]

DIFFERENTIAL SIDE OIL SEAL

Check the A/T fluid level. Refer to 

TM-231, "Adjustment"

.

FLUID COOLER TUBE

TM-247

< REMOVAL AND INSTALLATION >

[4AT: RE4F03C]

C

E

F

G

H

I

J

K

L

M

A

B

TM

N

O

P

FLUID COOLER TUBE

Exploded View

INFOID:0000000009268037

Removal and Installation

INFOID:0000000009268038

WARNING:

• Do not open the radiator cap or drain plug when the engine is hot. There is a danger that hot liquid

may spray out, causing serious injury.

• Perform these steps after the coolant temperature has cooled sufficiently.

CAUTION:

Do not reuse copper sealing washers.

NOTE:

Lift up the vehicle and perform the work from below.

REMOVAL

1. Remove fluid cooler hose and fluid cooler tube A.
2. Disconnect the washer from fluid cooler tube A. 
3. Remove fluid cooler hose and fluid cooler tube B.
4. Disconnect the washer from fluid cooler tube B. 

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Do not reuse copper sealing washers. 

When installing the fluid cooler tube A (1) and B (2) onto the tran-

saxle assembly, install it so that it is in contact with the transaxle

case rib (A).

1.

Fluid cooler tube A

2.

Copper sealing washer

3.

Fluid cooler tube B

4.

Bolt

5.

Transaxle assembly

JSDIA1937GB

JSDIA1977ZZ

TM-248

< REMOVAL AND INSTALLATION >

[4AT: RE4F03C]

FLUID COOLER TUBE

Inspection and Adjustment

INFOID:0000000009268039

INSPECTION AFTER INSTALLATION

Check for A/T fluid leakage. Refer to 

TM-230, "Inspection"

.

ADJUSTMENT AFTER INSTALLATION

Check the A/T fluid level. Refer to 

TM-231, "Adjustment"

.

FLUID COOLER HOSE

TM-249

< REMOVAL AND INSTALLATION >

[4AT: RE4F03C]

C

E

F

G

H

I

J

K

L

M

A

B

TM

N

O

P

FLUID COOLER HOSE

Exploded View

INFOID:0000000009315604

Removal and Installation

INFOID:0000000009315605

Inspection and Adjustment

INFOID:0000000009315606

INSPECTION AFTER INSTALLATION

Check for A/T fluid leakage. Refer to 

TM-230, "Inspection"

.

ADJUSTMENT AFTER INSTALLATION

Adjust the A/T fluid level. Refer to 

TM-231, "Adjustment"

.