|
|
B1065 – B1068, B1070 – B1073 PASSENGER AIRBAG MODULE SRC-43 < DTC/CIRCUIT DIAGNOSIS > C D E F G I J K L M A B SRC N O P 2. ERASE SELF-DIAG RESULT Erase the DTC using CONSULT. YES >> Inspection End. NO >> Refer to DTC CONFIRMATION PROCEDURE (Without CONSULT) 1. CHECK SELF-DIAG RESULT 1. Turn ignition switch ON. 2. Check the air bag warning lamp status. Refer to SRC-15, "Trouble Diagnosis without CONSULT" NOTE: SRS will not enter diagnosis mode if no malfunction is detected in user mode. YES >> Refer to NO >> Inspection End. Diagnosis Procedure INFOID:0000000009269144 1. HARNESS CONNECTOR Visually inspect all applicable harness connectors for the following: • Visible damage to connector or terminal • Loose terminal • Poor connection NOTE: All harness connectors should be inspected from the air bag diagnosis unit to the end component (including any in-line connectors). Is the inspection result normal? YES >> GO TO 2 NO >> Perform one of the following repairs: • Visible damage: Replace the harness. • Loose terminal: Secure the terminal. • Poor connection: Secure the connection. 2. CONFIRM DTC 1. Reconnect all harness connectors. 2. Turn ignition switch ON. 3. Check for DTC using CONSULT. YES >> GO TO 3 NO >> Refer to GI-45, "Intermittent Incident" . 3. WIRING HARNESS Check the wiring harness for visible damage NOTE . NOTE: The entire wiring harness should be inspected from the air bag diagnosis sensor unit to the end component (including any in-line connectors). YES >> GO TO 4 NO >> Replace the harness. 4. CONFIRM DTC 1. Reconnect all harness connectors. 2. Turn ignition switch ON. 3. Check for DTC using CONSULT. YES >> GO TO 5 |