|
|
TM-142 < DTC/CIRCUIT DIAGNOSIS > [CVT: RE0F11A] P0705 TRANSMISSION RANGE SENSOR A P0705 TRANSMISSION RANGE SENSOR A DTC Logic INFOID:0000000009019923 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1. PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2. CHECK DTC DETECTION 1. Start the engine. 2. Maintain the following conditions. 3. Shift the selector lever through entire positions from “P” to “L”. (Hold the selector lever at each position for 10 seconds or more.) 4. Check the first trip DTC. YES >> Go to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000009019924 1. CHECK TCM INPUT SIGNALS With CONSULT 1. Turn ignition switch ON. 2. Select “Data Monitor” in “TRANSMISSION”. 3. Select “D POSITION SW”, “N POSITION SW”, “R POSITION SW”, “P POSITION SW” and “L POSITION SW”. 4. Shift the selector lever through entire positions from “P” to “L” and check ON/OFF of each monitor item. DTC Trouble diagnosis name DTC detection condition Possible causes P0705 Transmission Range Sensor Two or more range signals simultaneously onds or more) - TCM power supply voltage: More than 11 V onds or more) - Vehicle speed: Less than 3 km/h (2 MPH) • Harness or connector (Short circuit between transmission • Transmission range switch Accelerator pedal position : 0.0/8 Brake pedal : Depressed Vehicle speed : 0 km/h (0 MPH) Monitor item Test condition Condition D POSITION SW Selector lever: “D” position On Other than the above Off |