|
|
P0AE6-225 HBC-465 < COMPONENT DIAGNOSIS > D E F G H I J K L M A B HBC N O P 2. Measure the voltage according to the value(s) in the table below when the ignition switch OFF. OK or NG OK >> GO TO 8. NG >> Repair or replace frame wire. 8. CHECK CONNECTOR CONNECTION CONDITION (BATTERY PACK WIRE CONNECTOR) HBC-140, "Diagnosis Procedure" OK or NG OK >> GO TO 9. NG >> Connect securely. 9. CHECK HARNESS AND CONNECTOR 1. Disconnect the battery pack wire connector (See HBB-97, "Removal and Installation" ). 2. Turn ignition switch ON. 3. Measure the voltage according to the value(s) in the table below. OK or NG OK >> GO TO 10. NG >> Repair or replace harness or connector. 10. CHECK HYBRID VEHICLE CONTROL ECU 1. Turn ignition switch OFF. 2. Measure the resistance according to the value(s) in the table below. OK or NG OK >> GO TO 11. NG >> GO TO 13. 11. CHECK CONNECTOR CONNECTION CONDITION (HYBRID VEHICLE CONVERTER CONNECTOR) HBC-140, "Diagnosis Procedure" OK or NG OK >> GO TO 12. NG >> Connect securely. 12. CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONVERTER - BATTERY PACK WIRE CONNECTOR) CAUTION: Be sure to wear insulated gloves. 1. Check that the service plug grip is not installed. 2. Disconnect the n4 hybrid vehicle converter (DC/DC converter) connector (See ). Frame Wire (A) Ground Voltage Harness connector Terminal E312 25 Ground 9 to 14V JMCIA0230ZZ Battery pack wire connector (A) Ground Voltage Harness connector Terminal B130 1 (IGCT) Ground 9 to 14V JMCIA0231ZZ Battery pack wire connector Ground Resistance Harness connector Terminal B130 8 (SMRP) Ground 370 to 430 k Ω |