|
|
P0A94-172 HBC-373 < COMPONENT DIAGNOSIS > D E F G H I J K L M A B HBC N O P • Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly. >> GO TO 2. 2. CHECK DTC OUTPUT (HYBRID SYSTEM) 1. Turn ignition switch ON. 2. Check DTC. NOTE: P0A94-172 may be set due to a malfunction which also causes DTCs in the table above to be set. In this case, first troubleshoot the output DTCs in the table above. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output. Is DTC detected? YES >> Go to Diagnosis Procedure relevant to output DTC. NO >> GO TO 3. 3. CHECK AMOUNT OF GASOLINE HBC-303, "Diagnosis Procedure" OK or NG OK >> GO TO 4. NG >> Refuel vehicle. 4. CHECK ENGINE START HBC-303, "Diagnosis Procedure" OK or NG OK >> GO TO 7. NG >> GO TO 5. DTC No. Relevant Diagnosis P0A1D (Except INF code 390) Hybrid Powertrain Control Module P0A1A (all INF codes) Generator Control Module P0A1B (all INF codes) Drive Motor “A” Control Module P0A72 (all INF codes) Generator Phase V Current P0A75 (all INF codes) Generator Phase W Current P0A60 (all INF codes) Drive Motor “A” Phase V Current P0A63 (all INF codes) Drive Motor “A” Phase W Current P0A4B-253 Generator Position Sensor Circuit P0A4D-255 Generator Position Sensor Circuit Low P0A4C-513 Generator Position Sensor Circuit Range/Performance P0A3F-243 Drive Motor “A” Position Sensor Circuit P0A41-245 Drive Motor “A” Position Sensor Circuit Low P0A40-500 Drive Motor “A” Position Sensor Circuit Range/Performance P0A78-266, 267, 523, 586, 284, 505, 287, 506, 113, 286, Drive Motor “A” Inverter Performance P0A94-585, 587, 589, 590, 554, 555, 556, 547, 548, 549, DC/DC Converter Performance P0A7A-322, 517, 325, 518, 122, 324, 344, 809, 810, 811, Generator Inverter Performance P0A92-521 Hybrid Generator Performance P0A90-509 Drive Motor “A” Performance P0AA6-526 Hybrid Battery Voltage System Isolation Fault P0AA6-613 Hybrid Battery Voltage Isolation Sensor Circuit |