|
|
HEADLAMP (HI) CIRCUIT EXL-225 < DTC/CIRCUIT DIAGNOSIS > [HALOGEN HEADLAMP] C D E F G H I J K M A B EXL N O P Is the inspection result normal? YES >> GO TO 5. NO >> Repair or replace harness. 3. CHECK HEADLAMP (HI) FUSE 1. Turn power switch OFF. 2. Check that the following fuses are not blown: Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-29, "Removal and Installation" . NO >> GO TO 4. 4. CHECK HEADLAMP HIGH (HI) SHORT CIRCUIT 1. Disconnect IPDM E/R connector. 2. Check continuity between IPDM E/R harness connector and ground. Is the inspection result normal? YES >> Replace fuse. (Replace IPDM E/R if the fuse is blown again.) NO >> Replace the blown fuse after repairing the affected circuit. 5. CHECK HEADLAMP (HI) GROUND OPEN CIRCUIT 1. Disconnect front combination lamp connector. 2. Check continuity between front combination lamp harness connector and ground. Is the inspection result normal? YES >> Replace headlamp (HI) bulb. NO >> Repair or replace harness. WITH DAYTIME RUNNING LIGHT SYSTEM INFOID:0000000010121447 1. CHECK HEADLAMP (HI) OPERATION CONSULT ACTIVE TEST 1. Select “EXTERNAL LAMPS” in “Active Test” of “IPDM E/R”. 2. While operating the test items, check that the headlamp (HI) is turned ON. IPDM E/R Front combination lamp Continuity Connector Terminal Connector Terminal RH E15 49 E45 2 Yes LH 50 E26 Unit Location Fuse No. Capacity Headlamp HI (RH) IPDM E/R 51 10 A Headlamp HI (LH) 52 IPDM E/R Ground Continuity Connector Terminal RH E15 49 No LH 50 Front combination lamp Ground Continuity Connector Terminal RH E45 4 Yes LH E26 |