|
|
BRC-90 < DTC/CIRCUIT DIAGNOSIS > [WITH VDC] C1115 WHEEL SENSOR 3. CHECK DATA MONITOR (1) With CONSULT 1. Erase “Self Diagnostic Result” of “ABS”. 2. Turn the power switch OFF → ON → OFF. CAUTION: Be sure to wait of 10 seconds after turning power switch OFF or ON. 3. Set the vehicle to READY. 4. Select “ABS” and “Data Monitor”, check the “FR LH SENSOR”, “FR RH SENSOR”, “RR LH SENSOR” and “RR RH SENSOR”. NOTE: Set the “Data Monitor” recording speed to “10 msec”. 5. Read a value (wheel speed) of both normal wheel sensors and error-detecting wheel sensor. wheel sensor and the maximum/minimum wheel speed detected by the normal wheel sensors, is the differ- ence within 5%, respectively? YES >> GO TO 4. NO >> GO TO 5. 4. PERFORM SELF DIAGNOSTIC (1) With CONSULT 1. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute. 2. Stop the vehicle. 3. Turn the power switch OFF → ON. CAUTION: • Be sure to wait of 10 seconds after turning power switch OFF or ON. • Set the vehicle to READY. 4. Repeat step 3 two or more times. 5. Perform “Self Diagnostic Result” of “ABS”. YES >> GO TO 5. NO >> Inspection End. 5. CHECK WHEEL SENSOR 1. Turn the power switch OFF. 2. Check the wheel sensor for damage. 3. Remove dust and foreign matter adhered to the sensor rotor with a vacuum dust collector through the wheel sensor mounting hole. CAUTION: Install wheel sensor with no backlash and float, and tighten the mounting bolt to the specified torque. • Front: Refer to BRC-158, "FRONT WHEEL SENSOR : Exploded View" • Rear: Refer to BRC-159, "REAR WHEEL SENSOR : Exploded View" Is the inspection result normal? YES >> GO TO 8. NO >> GO TO 6. 6. REPLACE WHEEL SENSOR (1) With CONSULT 1. Replace wheel sensor. - Front: Refer to BRC-158, "FRONT WHEEL SENSOR : Removal and Installation" - Rear: Refer to BRC-159, "REAR WHEEL SENSOR : Removal and Installation" 2. Erase “Self Diagnostic Result” of “ABS”. 3. Turn the power switch OFF → ON → OFF. CAUTION: Be sure to wait of 10 seconds after turning power switch OFF or ON. 4. Set the vehicle to READY. 5. Select “ABS” and “Data Monitor”, check the “FR LH SENSOR”, “FR RH SENSOR”, “RR LH SENSOR” and “RR RH SENSOR”. |