|
|
C1AA0 STROKE SENSOR BR-333 < DTC/CIRCUIT DIAGNOSIS > C D E G H I J K L M A B BR N O P Never operate the vehicle while waiting. 5. Turn the power switch ON without depressing the brake pedal. CAUTION: Never set the vehicle to READY. 6. Start CONSULT and erase self-diagnosis result of “BRAKE”. 7. Turn the power switch OFF to exit CONSULT, and disconnect CONSULT from data link connector. 8. Close all doors (including back door), check that the room lamp is OFF, get out of the vehicle, and wait for 3 minutes or more with all doors closed. CAUTION: Never operate the vehicle while waiting. 9. Turn the power switch ON without depressing the brake pedal. CAUTION: Never set the vehicle to READY. 10. Depress brake pedal by 100 mm (3.94 in) or more, and hold the position for 5 seconds or more. 11. Release brake pedal. 12. Start CONSULT and perform “BRAKE” self-diagnosis. YES >> GO TO 15. NO >> INSPECTION END 15. STROKE SENSOR 0 POINT LEARNING (1) With CONSULT Perform stroke sensor 0 point learning. Refer to Is either “COMPLETED” or “The operation is incomplete. Try again after confirming the operation condition.” displayed? “COMPLETED”>>GO TO 16. “The operation is incomplete. Try again after confirming the operation condition.”>>GO TO 17. 16. PERFORM SELF-DIAGNOSIS (7) With CONSULT 1. Turn the power switch OFF to ON without depressing the brake pedal. CAUTION: Never set the vehicle to READY. 2. Repeat step 1 two or more times. CAUTION: Be sure to wait for 5 seconds or more after turning the power switch OFF. 3. Turn the power switch OFF to exit CONSULT, and disconnect CONSULT from data link connector. 4. Close all doors (including back door), check that the room lamp is OFF, get out of the vehicle, and wait for 3 minutes or more with all doors closed. CAUTION: Never operate the vehicle while waiting. 5. Turn the power switch ON without depressing the brake pedal. CAUTION: Never set the vehicle to READY. 6. Start CONSULT and erase self-diagnosis result of “BRAKE”. 7. Turn the power switch OFF to exit CONSULT, and disconnect CONSULT from data link connector. 8. Close all doors (including back door), check that the room lamp is OFF, get out of the vehicle, and wait for 3 minutes or more with all doors closed. CAUTION: Never operate the vehicle while waiting. 9. Turn the power switch ON without depressing the brake pedal. CAUTION: Never set the vehicle to READY. 10. Depress brake pedal by 100 mm (3.94 in) or more, and hold the position for 5 seconds or more. 11. Release brake pedal. 12. Start CONSULT and perform “BRAKE” self-diagnosis. YES >> GO TO 17. NO >> INSPECTION END |