|
|
MA-14 < PERIODIC MAINTENANCE > ENGINE MAINTENANCE 4. Fill radiator and reservoir tank with water and reinstall radiator cap. engine coolant. 5. Install air duct (between air cleaner case and electric throttle control actuator). Refer to 6. Run the engine and warm it up to normal operating temperature. 7. Rev the engine two or three times under no-load. 8. Stop the engine and wait until it cools down. 9. Drain water from the system. Refer to . 10. Repeat steps 1 through 9 until clear water begins to drain from radiator. RESERVOIR TANK CAP RESERVOIR TANK CAP : Inspection INFOID:0000000006057340 • Check valve seat (A) of radiator cap. - Check that valve seat is swollen to the extent that the edge of the plunger cannot be seen when watching it vertically from the top. - Check that valve seat has no soil and damage. • Pull negative-pressure valve to open it, and that it close completely when released. - Check that there is no dirt or damage on the valve seat of radiator cap negative-pressure valve. - Check that there are no unusualness in the opening and closing conditions of negative-pressure valve. • Check radiator cap relief pressure. - When connecting radiator cap to the radiator cap tester (commer- cial service tool) (A) and the radiator cap tester adapter (commer- • Replace radiator cap if there is an unusualness related to the above three. CAUTION: When installing radiator cap, thoroughly wipe out the radiator filler neck to remove any waxy residue RADIATOR B : Metal plunger JPBIA0108ZZ SMA967B Standard and Limit : Refer to PBIC5122J |