|
|
INSPECTION AND ADJUSTMENT RF-25 < BASIC INSPECTION > C D E F G H I J L M A B RF N O P INSPECTION AND ADJUSTMENT ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT INFOID:0000000009176288 INITIALIZATION PROCEDURE Moonroof If the moonroof does not open or close automatically, use the following procedure to return moonroof opera- tion to normal. 1. Turn ignition switch ON. 2. Push and hold the moonroof tilt switch forward until the moonroof stops. 3. Release the moonroof switch. 4. Press and hold the tilt up switch within 6 seconds. 5. The roof glass will Tilt-Down → Slide-Close → Slide-Open → Slide-Close → Tilt-Up → Tilt-Down. 6. Release the switch, initialization is complete if the moonroof operates normally. Sunshade If the sunshade does not open or close automatically, use the following procedure to return sunshade opera- tion to normal. 1. Switch the vehicle ignition to the ACCESSORY or RUN mode. 2. Press and hold the sunshade close switch. 3. Sunshade will begin moving towards the close position only while the switch is continually pressed. (this disables the obstacle detection). 4. Sunshade will stop for about 4 seconds. 5. Sunshade drive cable will travel in the open direction for 10 mm (.394 in.) then reverse direction and stop at the normal close position. 6. Release the sunshade close switch. Initialization procedure is complete. ANTI-PINCH FUNCTION Moonroof 1. Fully open the moonroof to the full open position. 2. Place a piece of wood at the fully closed position. 3. Close the moonroof completely with auto-slide close function. 4. Moonroof should make contact and then tilt up or travel in reverse for 125mm (4.92 in.). Sunshade 1. Open the sunshade to the full open position. 2. Place a piece of wood at the fully closed position. 3. Close the sunshade completely with auto-slide close function. 4. Sunshade should make contact and then travel in reverse for 100mm (3.94 in.). CAUTION: • Do not test the anti-pinch function with your hands or other body parts because they may be pinched. • Depending on the environment and driving conditions, if a similar impact or load is applied to the moonroof it may lower. • Test the auto-slide operation before inspection when the initialization procedure is performed. • Perform the initialization procedure when the auto-slide operation or anti-pinch function does not operate normally. |