|
|
REAR DOOR GLASS AND REGULATOR GW-21 < REMOVAL AND INSTALLATION > C D E F G H I J L M A B GW N O P 4. Operate the rear power window switch to raise/lower the rear door glass until the rear door regulator to glass bolts (A) can be seen and remove. 5. Raise the rear door glass and hold in place with suitable tool or approximately two inches of masking tape. guide channel nuts (A). 7. Disconnect the harness connector from the rear door glass reg- ulator motor (1). 8. Remove rear door regulator to glass bolts (B) and the rear door glass regulator. 9. Remove power window motor from rear door glass regulator (if necessary). Refer to Inspection after removal Check the rear door glass regulator for the following items: • Gear wear • Rear door glass regulator deformation • Spring damage • Grease condition for each sliding part If a malfunction is detected, replace or grease it. Installation 1. Install power window motor to rear door glass regulator (if necessary). Refer to . ALKIA3220ZZ ALKIA2364ZZ ALKIA2365ZZ |