|
|
Content .. 1205 1206 1207 1208 ..
WT-10 < SYSTEM DESCRIPTION > DIAGNOSIS SYSTEM (BCM) DIAGNOSIS SYSTEM (BCM) COMMON ITEM INFOID:0000000009763995 CAUTION: After disconnecting the CONSULT vehicle interface (VI) from the data link connector, the ignition must be cycled OFF → ON (for at least 5 seconds) → OFF. If this step is not performed, the BCM may not go to ”sleep mode”, potentially causing a discharged battery and no-start condition. APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions. Direct Diagnostic Mode Description Ecu Identification The BCM part number is displayed. Self Diagnostic Result The BCM self diagnostic results are displayed. Data Monitor The BCM input/output data is displayed in real time. Active Test The BCM activates outputs to test components. Work support The settings for BCM functions can be changed. Configuration • The vehicle specification can be read and saved. CAN Diag Support Mntr The result of transmit/receive diagnosis of CAN communication is displayed. System Sub System Direct Diagnostic Mode Ecu I de nti ficat ion Se lf Di ag no sti c Res ult Dat a Monitor Active T e st W ork su pp ort Co nf ig ur at io n CAN Diag Su pp ort Mn tr Door lock DOOR LOCK × × × × Rear window defogger REAR DEFOGGER × × × Warning chime BUZZER × × Interior room lamp timer INT LAMP × × × Exterior lamp HEADLAMP × × × Wiper and washer WIPER × × × Turn signal and hazard warning lamps FLASHER × × Air conditioner AIR CONDITIONER × Intelligent Key system INTELLIGENT KEY × × × × Combination switch COMB SW × BCM BCM × × × × × Immobilizer IMMU × × × Interior room lamp battery saver BATTERY SAVER × × Back door open TRUNK × Vehicle security system THEFT ALM × × × RAP system RETAINED PWR × |