|
|
|
Content .. 1104 1105 1106 1107 ..
PRECAUTIONS ST-3 < PRECAUTION > C D E F H I J K L M A B ST N O P PRECAUTION PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT INFOID:0000000009177053 The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Instruction. WARNING: • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer. • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section. • Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Instruction. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har- ness connectors. PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: • When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni- tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury. • When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service. Service Notice or Precautions for Steering System INFOID:0000000009177054 • In case of removing steering gear, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment. • Observe the following precautions when disassembling. - Before disassembly, thoroughly clean the outside of the unit. - Disassembly should be done in a clean work area. It is important to prevent the internal parts from becoming contaminated by dirt or other foreign matter. - For easier and proper assembly, place disassembled parts in order on a parts rack. - Use nylon cloth or paper towels to clean the parts; common shop rags can leave lint that might interfere with their operation. - Never reuse non-reusable parts. - Before assembling, apply the specified grease to the directed parts. |