|
|
CENTER CONSOLE ASSEMBLY IP-25 < ON-VEHICLE REPAIR > C D E F G H I K L M A B IP N O P 12. Remove instrument lower cover RH. • Disengage instrument lower cover LH (1) fixing clip, pawl and metal clips. • Pull the instrument lower cover RH crosswise. 13. Remove selector lever knob. Refer to TM-155, "Removal and Installation" . 14. Remove console switch panel. • Disengage pawls of console switch panel (1) with remover tool (A). • Pull up console switch panel. 15. Remove console finisher assembly. • Put selector lever in the [N] position. pawls sequentially from the front side with remover tool. • Pull console finisher assembly, upward to disengage from cen- ter console. • Disconnect harness connectors. 16. Remove control device upper case. • Put selector lever in the [P] position. trol device assembly. • Disconnect harness clip (B). 17. Remove console rear finisher. • Pull back console rear finisher (1) by using a remover tool (A), then disengage pawls and metal clips. • Disconnect inside key antenna connector. : Clip : Pawl : Metal clip JMJIA1903ZZ : Pawl JMJIA1904ZZ : Pawl : Metal clip JMJIA1905ZZ JMJIA1906ZZ : Pawl : Metal clip JMJIA1907ZZ |