|
|
содержание .. 527 528 529 530 ..
B242A CLOSURE CONDITION DLK-457 < DTC/CIRCUIT DIAGNOSIS > [TYPE 2] C D E F G H I J L M A B DLK N O P Is the inspection result normal? YES >> GO TO 7. NO >> GO TO 4. 4. CHECK SWITCH INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door lock assembly connector. 3. Check voltage between back door lock assembly harness connector and ground. Is the inspection result normal? YES >> GO TO 6. NO >> GO TO 5. 5. CHECK SWITCH CIRCUIT 1. Disconnect automatic back door control unit connector. 2. Check continuity between automatic back door control unit harness connector and back door lock assem- 3. Check continuity between automatic back door control unit harness connector and ground. Is the inspection result normal? YES >> Replace automatic back door control unit. Refer to DLK-633, "Removal and Installation" . NO >> Repair or replace harness. 6. CHECK SWITCH GROUND CIRCUIT Check continuity between back door lock assembly harness connector and ground. Monitor item Condition Status HALF LATCH SW Back door Fully closed OFF Open ON OPEN SW Closure operation ON Other than above OFF CLOSE SW Closure operation ON Other than above OFF (+) (–) Voltage (Approx.) Back door lock assembly Connector Terminal D172 4 Ground 12.2 V 5 12.2 V 6 12 V Automatic back door control unit Back door lock assembly Continuity Connector Terminal Connector Terminal B24 3 D172 6 Existed 5 5 11 4 Automatic back door control unit Ground Continuity Connector Terminal B24 3 Not existed 5 11 |