|
|
CVT FLUID TM-615 < PERIODIC MAINTENANCE > [CVT: RE0F10G] C E F G H I J K L M A B TM N O P 34. Select “Data Monitor” in “TRANSMISSION” using CONSULT. 35. Select “CONFORM CVTF DETERIORTN”. 37. Perform air bleeding of electric oil pump. Refer to 38. Stop the engine. Adjustment INFOID:0000000010245673 CAUTION: • During adjustment of the CVT fluid level, check CONSULT so that the oil temperature may be main- tained from 35 to 45 ° C (95 to 113 ° F). • During adjustment of the CVT fluid level, check that the engine speed is maintaining 500 rpm. 1. Check that the selector lever is in the “P” position, then completely engage the parking brake. 2. Start the engine. 3. Adjust the CVT fluid temperature to be approximately 40 ° C (104 ° F). NOTE: 4. While depressing the brake pedal, shift the selector lever to the entire position from “P” to “D”, and shift it 5. Lift up the vehicle. 6. Check that there is no CVT fluid leakage. 7. Remove the overflow plug from converter housing. 8. Install the charging pipe set (KV311039S0) (A) into the overflow CAUTION: Tighten the charging pipe by hand. 9. Install the ATF changer hose (B) to the charging pipe. CAUTION: Press the ATF changer hose all the way onto the charging 10. Fill approximately 0.5 liter (1/2 lmp qt) of the CVT fluid. check that the CVT fluid drains out from the charging pipe. If it CAUTION: Perform this work with the vehicle idling. 12. When the flow of CVT fluid slows to a drip, remove the charging pipe from the converter housing. . CAUTION: Never reuse O-ring. Recommended fluid and fluid capacity : Refer to MA-59, "Fluids and Lubricants" : Vehicle front JSDIA3714ZZ JSDIA3713ZZ |