|
|
Content .. 2167 2168 2169 2170 ..
DAS-90 < BASIC INSPECTION > [DRIVER ASSISTANCE SYSTEM] DISTANCE SENSOR ALIGNMENT DISTANCE SENSOR ALIGNMENT Description INFOID:0000000010608813 OUTLINE OF RADAR ALIGNMENT PROCEDURE • A 4-wheel vehicle alignment must be performed before proceeding with radar alignment procedure. WARNING: Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should CAUTION: The system does not operate normally unless the radar alignment is performed. Always perform it. Preparation, refer to DAS-90, "Work Procedure (Preparation)" 2. Set the ICC target board (SST: KV99112700) to the correct position in front of the vehicle. Refer to 92, "Work Procedure (Setting The ICC Target Board)" . 3. Set the radar alignment mode (“MILLIWAVE RADAR ADJUST” on “Work support”) with CONSULT, and DAS-93, "Work Procedure (Radar Align- CAUTIONARY POINT FOR RADAR ALIGNMENT PROCEDURE CAUTION: • For radar alignment procedure, choose a level location with a few meter of working space in front and surrounding the vehicle. • Vehicle must be stationary and unoccupied during the whole alignment procedure. will have to restart the alignment process. • The ignition switch must be in the ON position. maintain adequate battery voltage will cause the test to fail. If this happens, you will have to restart • The ICC target board must be set in front of the vehicle facing the sensor. out CONSULT.) • Never enter the vehicle during radar alignment. process. • Accurate steering wheel setting is crucial. Once set, do not disturb the steering wheel for the remainder of the alignment procedure. • For proper system operation and adjustment, all vehicle wheels must be of the same size. Work Procedure (Preparation) INFOID:0000000010608814 1. ADVANCE PREPARATION FOR RADAR ALIGNMENT 1. Adjust all tire pressure to the specified value. 2. Empty the vehicle. (Remove any luggage from the passenger compartment, trunk room, etc.) 3. Shift the selector lever to “P” position, and release the parking brake. 4. Fully fill the fuel tank, and then check that the coolant and oils are filled up to correct level. 5. Clean the right front side of the fascia in front of the distance >> GO TO 2. JMOIA0055ZZ |