|
|
Content .. 1417 1418 1419 1420 ..
BACK DOOR DLK-945 < REMOVAL AND INSTALLATION > [TYPE 6] C D E F G H I J L M A B DLK N O P REMOVAL 1. Remove back door trim finisher lower and back door trim finisher upper. Refer to . 2. Remove rear washer tube from back door panel. Refer to WW-90, "WASHER TUBE : Removal and Instal- . 3. Disconnect back door harness connectors from body harness connectors. 4. Remove harness grommet from back door panel. 5. Pull out body harness LH from back door panel. 6. Support back door with the proper material to prevent it from falling. WARNING: Bodily injury may occur if no supporting rod is holding the back door open when removing the 7. Remove back door stay of back door side. Refer to DLK-948, "BACK DOOR STAY : Removal and Installa- 8. Remove back door mounting nuts, and then remove back door assembly. INSTALLATION Note the following items, and install in the reverse order of removal. CAUTION: • After installation, perform the fitting adjustment. Refer to DLK-945, "BACK DOOR ASSEMBLY : • Apply touch-up paint to the body color if the paint around back door hinge is peeled off. BACK DOOR ASSEMBLY : Adjustment INFOID:0000000010678878 FITTING ADJUSTMENT |