|
|
CYLINDER BLOCK EM-99 < UNIT DISASSEMBLY AND ASSEMBLY > [HRA2DDT] C D E F G H I J K L M A EM N P O • Position the 3 parts oil ring with the end gap placed as shown in the figure referring to the piston front mark (A). 9. Install connecting rod bearings to connecting rod and connecting rod cap. apply engine oil to the back surface, but thoroughly clean it. • Install the bearing in the center position. NOTE: • Check that the oil holes on connecting rod and connecting rod bearing are aligned. ure. NOTE: 10. Install piston and connecting rod assembly to crankshaft. • Position crankshaft pin corresponding to connecting rod to be installed onto the bottom dead center. 1 : Upper rail 2 : Spring 3 : Lower rail E1BIA1108ZZ 1 : Connecting rod 2 : Connecting rod bearing (upper) 3 : Connecting rod bearing (lower) 4 : Connecting rod cap A : 2.05 - 2.07 mm (0.0807 - 0.0815 in) : Engine front PBIC4169E |