Nissan Juke F15. Instruction - part 902

INT-12

< SYMPTOM DIAGNOSIS >

SQUEAK AND RATTLE TROUBLE DIAGNOSES

PIIB8742E

FRONT DOOR FINISHER

INT-13

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

REMOVAL AND INSTALLATION

FRONT DOOR FINISHER

Exploded View

INFOID:0000000012199168

Removal and Installation

INFOID:0000000012199169

REMOVAL

CAUTION:

• When removing. always use a remover tool that is made of plastic.

• Never damage the door panel.
1. Fully open door window.
2. Remove pull handle.

1.

Front door panel

2.

Front door finisher

3.

Cap

4.

Pull handle

5.

Power window switch finisher

6.

Pull handle bracket

: Clip

: Pawl

: Metal clip

JMJIA4517ZZ

INT-14

< REMOVAL AND INSTALLATION >

FRONT DOOR FINISHER

1. Remove cap in the pull handle.

2. Remove pull handle fixing screw.

3. Lift up the pull handle while rotating it in direction indicated

by the arrow as shown in the figure. Disengage pawls and

remove the pull handle.

3. Remove power window switch finisher and power window switch in one body.

1. Disengage power window switch finisher fixing pawl with a

remover tool (A).

CAUTION:

Apply protective tape (B) on the parts to protect it from

damage.

2. Pull up power window switch finisher and power window

switch with one body and disconnect harness connector.

4. Remove door mirror corner cover. Refer to 

MIR-17, "DOOR MIRROR ASSEMBLY : Removal and Installa-

tion"

.

5. Disengage front door finisher fixing clips and metal clips with a

remover tool (A), and then remove front door finisher.

CAUTION:

Insert a remover tool between body side panel and clip and

disengage pawl.

NOTE:

Remove power window switch. Refer to 

PWC-54, "Removal and Installation"

.

INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:

JMJIA4518ZZ

: Pawl

JMJIA4519ZZ

: Pawl

JMJIA4520ZZ

: Clip

: Metal clip

JMJIA4521ZZ

FRONT DOOR FINISHER

INT-15

< REMOVAL AND INSTALLATION >

C

D

E

F

G

H

I

K

L

M

A

B

INT

N

O

P

When installing front door finisher, check that clips, and metal clips are securely in body panel holes,

and press them in.