|
|
содержание .. 1284 1285 1286 1287 ..
PARK/NEUTRAL POSITION (PNP) SWITCH TM-195 < ON-VEHICLE REPAIR > [TYPE 1 (4AT: RE4F03B)] C E F G H I J K L M A B TM N O P PARK/NEUTRAL POSITION (PNP) SWITCH Park/Neutral Position (PNP) Switch INFOID:0000000001733159 COMPONENTS REMOVAL 1. Remove the air duct. Refer to EM-27, "Removal and Installation" . 2. Disconnect the PNP switch connector. 3. Disconnect the control cable from the PNP switch. 4. Remove the PNP switch bolts and the PNP switch. INSTALLATION Installation is in the reverse order of removal. TM-204, "Checking of A/T Position" TM-204, "Adjustment of A/T Position" . • After installation is completed, check continuity of PNP switch. Refer to . PARK/NEUTRAL POSITION (PNP) SWITCH ADJUSTMENT 1. Set selector lever and instruction shaft (1) in “N” position. 2. Remove the air duct. Refer to EM-27, "Removal and Installation" . 3. Remove control cable from instruction shaft (1). 4. Loosen PNP switch bolts. : Bolt 5. Insert the pin (3) [4 mm (0.16 in) dia.] straight into instruction shaft 6. Rotate PNP switch (2) until the pin (3) can also be inserted 7. Tighten PNP switch bolts to the specified torque. 8. Remove the pin (3) from adjustment hole after adjusting PNP 9. Check continuity of PNP switch (2). Refer to 10. Adjust and check A/T position. Refer to TM-204, "Checking of A/T Position" . 1. A/T 2. PNP switch SCIA6204J SCIA6218J |