|
|
|
TEST ACTION APPLICABILITY 4 NOTE: Prior to performing this test, be sure to check the Glow Plug Relay All Yes → Go To 5 No → Repair as necessary. Perform NO START VERIFICATION - VER-1. 5 Inspect the fuel system lines for restrictions, leaks or other problems. All Yes → Repair as necessary. Perform NO START VERIFICATION - VER-1. No → Go To 6 6 Refer to the Service Information and perform the fuel pressure test. All Yes → Go To 7 No → Repair as necessary. Perform NO START VERIFICATION - VER-1. 7 Inspect the fuel supply for contamination. All Yes → Refer to the Service Information to remove and replace fuel throughout the fuel system. No → Go To 8 8 Turn the ignition off. t lab scope, backprobe the CMP Sensor Signal circuit at the ECM harness connector. t. NOTE: Refer to Charts and Graphs to view a correct CMP Sensor signal. t display a steady clean CMP Signal pattern? All Yes → Go To 9 No → Perform Test for DTC P2043-Camshaft Position Sensor Circuit Static Plausibility. 240 DRIVEABILITY - DIESEL *ENGINE CRANKS BUT WILL NOT START — Continued |