Mercedes-Benz Sprinter / Dodge Sprinter. Service manual - part 86

 

  Index      Mercedes     Mercedes-Benz Sprinter / Dodge Sprinter - service and repair manual 2006 year

 

Search            copyright infringement  

 

 

 

 

 

 

 



 

 

Content   ..  84  85  86  87   ..

 

 

Mercedes-Benz Sprinter / Dodge Sprinter. Service manual - part 86

 

 

Symptom:

LATERAL ACCELERATION SENSOR INTERNAL FAULT

POSSIBLE CAUSES

LATERAL ACCELERATION SENSOR CIRCUIT INTERMITTENT DTC

LATERAL ACCELERATION SENSOR

TEST

ACTION

APPLICABILITY

1

Turn the ignition off.
Turn the ignition on.
With the DRBIII

t, read DTCs. Record DTC information.

NOTE: If a system undervoltage or overvoltage DTC is set along with this
DTC, diagnose the system voltage DTC first.
NOTE: Electromagnetic (radio) interference can cause an intermittent
system malfunction by interrupting communication between the sensor
and the CAB.
With the DRBIII

t, erase DTCs.

Road test the vehicle and perform several steering and braking maneuvers.
With the DRBIII

t, perform the road test procedure.

With the DRBIII

t, read DTCs.

Does this DTC reset?

All

Yes

→ Replace the Lateral Acceleration Sensor in accordance with the

Service Information.

No

→ Go To 2

2

The condition that set this DTC is not present at this time.
Monitor the DRBIII

t while wiggle testing the related harness and connectors. Look

for any related parameters to change or for the DTC to reset.
Inspect the related harness and connectors.
Look for any chafed, pierced, pinched, or partially broken wires.
Look for broken, bent, pushed out, or corroded terminals.
Were any problems found?

All

Yes

→ Repair as necessary.

No

→ Test Complete.

39

BRAKES (CAB)

Symptom List:

LEFT FRONT INLET SOLENOID
LEFT FRONT OUTLET SOLENOID
LEFT FRONT, RIGHT REAR INLET SOLENOID
LEFT FRONT, RIGHT REAR OUTLET SOLENOID
LEFT REAR INLET SOLENOID
LEFT REAR OUTLET SOLENOID
RIGHT FRONT INLET SOLENOID
RIGHT FRONT OUTLET SOLENOID
RIGHT FRONT, LEFT REAR INLET SOLENOID
RIGHT FRONT, LEFT REAR OUTLET SOLENOID
RIGHT REAR INLET SOLENOID
RIGHT REAR OUTLET SOLENOID

Test Note:

All symptoms listed above are diagnosed using the same tests.

The title for the tests will be LEFT FRONT INLET SOLE-
NOID.

When Monitored and Set Condition:

LEFT FRONT INLET SOLENOID

When Monitored:

Ignition On - Continuousy

Set Condition:

When the electrical feedback signal does not match the actuation signal

for the solenoid OR during the solenoid and pump motor test when all solenoids are tested
in series and a solenoid response signal is detected.

POSSIBLE CAUSES

INTERMITTENT SOLENOID DTC

DAMAGED CAB/CAB HARNESS CONNECTOR

FUSED OPTIONAL EQUIPMENT RELAY OUTPUT CIRCUIT OPEN

FUSED B(+) CIRCUIT OPEN

GROUND CIRCUIT OPEN

ANTI-LOCK BRAKE CONTROLLER

40

BRAKES (CAB)

TEST

ACTION

APPLICABILITY

1

NOTE: If a system undervoltage or overvoltage DTC is set along with this
DTC, diagnose the system voltage DTC first.
Turn the ignition on.
With the DRBIII

t, read DTCs.

With the DRBIII

t, erase DTCs.

Turn the ignition off.
Turn the ignition on.
Start the engine.
Drive the vehicle over 15 km/h (10 mph) to test solenoid and pump circuits.
Stop the vehicle.
With the DRBIII

t, read DTCs.

Does the DRBIII

t display any SOLENOID DTCs?

All

Yes

→ Go To 2

No

→ Go To 6

2

Turn the ignition off.
Disconnect the CAB harness connector.
Inspect the CAB/CAB harness connector for damage.
Is there any broken, bent, pushed out, corroded or spread terminals?

All

Yes

→ Repair as necessary.

Perform ABS VERIFICATION TEST - VER 1.

No

→ Go To 3

3

Turn the ignition off.
Disconnect the CAB harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, check the Fused Optional Equipment
Relay Output circuit at the CAB harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?

All

Yes

→ Go To 4

No

→ Repair the Fused Optional Equipment Relay Output circuit for an

open.
Perform ABS VERIFICATION TEST - VER 1.

4

Turn the ignition off.
Disconnect the CAB harness connector.
Using a 12-volt test light connected to ground, check both Fused B(+) circuits at the
CAB harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?

All

Yes

→ Go To 5

No

→ Repair the Fused B(+) circuit for an open.

Perform ABS VERIFICATION TEST - VER 1.

41

BRAKES (CAB)

LEFT FRONT INLET SOLENOID —

Continued

TEST

ACTION

APPLICABILITY

5

Turn the ignition off.
Disconnect the CAB harness connector.
Using a 12-volt test light connected to 12-volts, check the CAB harness connector
Ground circuits.
NOTE: The test light must illuminate brightly. Compare the brightness to
that of a direct connection to the battery.
Does the test light illuminate brightly?

All

Yes

→ Replace the Controller Antilock Brake in accordance with the

Service Information.
Perform ABS VERIFICATION TEST - VER 1.

No

→ Repair the Ground circuit for an open.

Perform ABS VERIFICATION TEST - VER 1.

6

Turn the ignition off.
Visually inspect the related wiring harness.
Look for any chafed, pierced, pinched, or partially broken wires.
Look for broken, bent, pushed out, or corroded terminals.
Were any problems found?

All

Yes

→ Repair as necessary.

Perform ABS VERIFICATION TEST - VER 1.

No

→ Test Complete.

42

BRAKES (CAB)

LEFT FRONT INLET SOLENOID —

Continued

 

 

 

 

 

 

 

Content   ..  84  85  86  87   ..