|
|
GO to Pinpoint Test G557182t8.
G557182t8 : CHECK THE STARTER RELAY OUTPUT VOLTAGE AT THE FUSE 1. Key off. 2. Disconnect the front power distribution box connector, EC04. 3. Key on, engine cranking. 4. Measure the voltage between: EC04, component side Battery
Pin 03
Negative terminal
Is the voltage less than 10 volts? -> Yes GO to Pinpoint Test G557182t6.
-> No REPAIR the solenoid supply circuit as necessary. For additional information, refer to the wiring diagrams. Test the system for normal operation. G557182t6 : CHECK THE IGNITION SWITCHED SUPPLY TO THE STARTER 1. Key off. 2. Disconnect the front power distribution box connector, EC41. 3. Key on, engine cranking. 4. Measure the voltage between: EC41, harness side Battery
Pin 01
Negative terminal
Is the voltage greater than 10 volts? -> Yes GO to Pinpoint Test G557182t9.
-> No REPAIR the switched supply circuit as necessary. For additional information, refer to the wiring diagrams. Test the system for normal operation. |