|
|
6E2–319 RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS DTC P0420 –TWC System Low Efficiency Bank 1
Step Action Value(s) Yes No 1 Was the “On-Board Diagnostic (OBD) System Check” — Go to Step 2 Go to OBD System Check 2 Are any other DTCs set (such as P0140, P0146)? — Diagnose other DTC(s) first Go to Step 3 3 1. Visually and physically inspect the three-way catalytic converter for damage. Check for the f dents f severe discoloration caused by excessive f holes f internal rattle caused by damaged catalyst 2. Also, ensure that the three-way catalytic converter is a proper original equipment manufacturer part. Did your inspection reveal a problem? — Go to Step 6 Go to Step 4 4 1. Visually and physically inspect the exhaust system between the three-way catalytic converter and the 2. If a problem is found, repair as necessary. Did your inspection reveal a problem? — Go to Step 7 to verify repair Go to Step 5 5 1. Visually and physically inspect the Bank 1 HO2S 2. the pigtail and wiring harness is not contacting the 3. If a problem is found, repair as necessary. Did your inspection reveal a problem? — Go to Step 7 to verify repair Go to Step 6 6 Replace the three-way catalytic converter. NOTE: Check for conditions which may cause catalyst Diagnostic Aids). Is the action complete? — Go to Step 7 to verify repair — 7 1. Review and record the Tech 2 Failure Records data. engine coolant temperature monitored on the Tech 4. Run the engine to maintain the specified mass air flow range for at least 2 minutes. 5. Operate the vehicle to maintain DTC P0420 test conditions (refer to DTC Test Description in Diagnostic Support for detailed instructions). 6. Using a Tech 2, monitor “DTC” info for DTC P0420 until the DTC P0420 test runs. 7. Note the test result. Does the Tech 2 indicate DTC P0420 passed this Engine coolant temp: greater than 60 ° C (140 ° F). Mass air flow: between 8 g/second and 50 g/second Repair complete. If a driveability symptom still exists, refer to Symptoms. Go to the Diagnostic Aids. |